Home › Vehicle Exterior › HORN › RELAY
RM25T0E _59 Vehicle Exterior _029941 HORN _0137781 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28380A 1.REMOVE FUEL PUMP RESISTOR (for 1GR-FE)

Hide 74403A 3.REMOVE BATTERY CARRIER SUB-ASSEMBLY (for 1HZ, 1VD-FTV)

Hide 82610A 4.DISCONNECT FUSE BLOCK ASSEMBLY

Hide 86530 5.REMOVE HORN RELAY ASSEMBLY

a.

Remove the relay block cover.


b.

Remove the horn relay assembly from the engine room relay block.

B234346C01
0.344,1.281 0.698,1.552 0.354,0.271 10 false *A 2.563,1.292 2.896,1.51 0.333,0.219 10 false *B 5.135,1.271 5.438,1.583 0.302,0.313 10 false *C
*A for 1VD-FTV *B for 1GR-FE, for 1HZ (12 V Battery)
*C for 1HZ (24 V Battery) - -



Hide 86530 6.INSPECT HORN RELAY ASSEMBLY

a.
B171171N01
2.531,1.104 2.958,1.104 true 2.531,1.583 2.979,1.583 true 2.615,0.563 2.906,0.188 true 2.021,0.563 1.729,0.208 true 0.229,0.75 0.385,0.927 0.156,0.177 10 false 3 1.198,0.75 1.354,0.927 0.156,0.177 10 false 5 1.198,1.26 1.354,1.438 0.156,0.177 10 false 1 0.24,1.271 0.396,1.448 0.156,0.177 10 false 2 3.021,1.51 3.177,1.688 0.156,0.177 10 false 3 3,1.021 3.156,1.198 0.156,0.177 10 false 5 1.615,0.094 1.771,0.271 0.156,0.177 10 false 1 2.958,0.104 3.115,0.281 0.156,0.177 10 false 2

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage is applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the horn relay assembly.


Hide 86530 7.INSTALL HORN RELAY ASSEMBLY

a.

Install the horn relay assembly to the engine room relay block.


b.

Install the relay block cover.


Hide 74403A 9.INSTALL BATTERY CARRIER SUB-ASSEMBLY (for 1HZ, 1VD-FTV)

Hide 28380A 11.INSTALL FUEL PUMP RESISTOR (for 1GR-FE)