RM25T0E _V1 General _030611 INTRODUCTION _0140189 REPAIR INSTRUCTION D
INTRODUCTION REPAIR INSTRUCTION INITIALIZATION
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
| ECM |
Register VIN |
DTC P0630 is output |
( )(for 1GR-FE) ( )(for 1VD-FTV) |
| Supply pump initialization (for 1VD-FTV) |
Engine startability |
( ) |
| Fuel injector(s) (for 1VD-FTV) |
Injector compensationcode(s) registration |
DTC is output. |
( ) |
| Fuel supply pump (for 1VD-FTV) |
Supply pump initialization |
Engine startability |
( ) |
·
Transponder key ECU assembly
|
Registration |
Engine starting |
Refer to the Service Bulletin for the registration procedure. |
·
Door control with receiver ECU assembly
|
Register recognition code |
Wireless door lock operation |
( ) |
| Timing belt (for 1HZ) |
Information mode reset operation |
·
Does not illuminate when replacement is necessary
·
Illuminates when replacement is not necessary
|
( ) |