77035 1.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Attach the cable to the clamps as shown in the illustration.
| *A | for Model Code #J71 Series | *B | for Model Code #J76 Series |
Attach the cable to the clamps as shown in the illustration.
77377 2.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
Install the fuel filler opening lid lock retainer in the direction indicated by the arrow in the illustration.
for Model Code #J71 Series:
Align the claws on the body with the retractor sub-assembly positioning holes.
Install the retractor sub-assembly with the bolt.
57627C 3.INSTALL REAR FLOOR SIDE MEMBER COVER RH (for Model Code #J71 Series)
| *a | Mark |
Install the rear floor side member cover with the 2 screws.
Be sure to install the cover so that the mark on the cable is not visible.
62511 4.INSTALL QUARTER INSIDE TRIM BOARD RH
for Model Code #J76 Series:
Attach the 12 clips to install the cowl side trim sub-assembly.
for Model Code #J71 Series
Attach the 13 clips to install the cowl side trim sub-assembly.
73297B 5.INSTALL QUARTER TRIM BELT HOLE COVER RH (for Model Code #J71 Series)
Install the quarter trim belt hole cover with the 2 screws.
73298 6.INSTALL NO. 2 QUARTER TRIM BELT HOLE COVER RH (for Model Code #J71 Series)
Install the No. 2 quarter trim belt hole cover with the 2 screws.
62551F 7.INSTALL REAR SEAT SIDE GARNISH RH (for Model Code #J76 Series)
Slide the garnish in the direction of the arrow shown in the illustration to install the rear seat side garnish.
Attach the 2 clips.
62414A 8.INSTALL LOWER CENTER PILLAR GARNISH LH (for Model Code #J76 Series)
62413A 9.INSTALL CENTER LOWER PILLAR GARNISH RH (for Model Code #J76 Series)
Use the same procedure described for the LH side.
67918A 10.INSTALL REAR DOOR SCUFF PLATE LH (for Model Code #J76 Series)
67917A 11.INSTALL REAR DOOR SCUFF PLATE RH (for Model Code #J76 Series)
Use the same procedure described for the LH side.
62112A 12.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
58191 13.INSTALL FRONT FLOOR FOOTREST
67914 14.INSTALL FRONT DOOR SCUFF PLATE LH
for Model Code #J76 Series:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-long Body)>INSTALLATION
for Model Code #J71 Series:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Short Body)>INSTALLATION
67913 15.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
55480D 16.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
77306 17.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly.
Attach the 3 claws to install the hood lock control lever sub-assembly.
18.INSTALL FRONT SEAT
for Separate Seat Type:
for Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION