Home › Engine / Hybrid System › 1VD-FTV (STARTING) › STARTER › 2016.08–2022.09
RM25T0E _51 Engine / Hybrid System _029900 1VD-FTV STARTING _0137002 STARTER A

1VD-FTV STARTING  STARTER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/ DPF:

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.

Click hereEngine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM (w/ DPF)>ON-VEHICLE INSPECTION



PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


b.

Connect the 2 hoses to the starter assembly and starter hose bracket sub-assembly.


c.

Attach the harness clamp and connect the wire harness.


d.

Connect the starter wire to the starter assembly with the nut.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)


e.

Connect the connector to the starter assembly.


Hide 23920A 2.INSTALL FUEL COOLER ASSEMBLY (w/o DPF)

Hide 25680 3.INSTALL EGR VALVE WITH EGR COOLER (w/o DPF)

Hide 25680 4.INSTALL EGR COOLER ASSEMBLY (w/ DPF)

Hide 28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL