25630 1.INSTALL NO. 2 EGR VALVE ASSEMBLY
25601 2.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
1628A 3.INSTALL NO. 6 WATER BY-PASS PIPE WITH NO. 7 WATER BY-PASS HOSE
25680 4.INSTALL EGR COOLER SUB-ASSEMBLY
17114D 5.INSTALL NO. 3 INTAKE MANIFOLD
23810A 6.INSTALL COMMON RAIL LH
23820A 7.INSTALL COMMON RAIL RH
23705 8.INSTALL NO. 5 INJECTION PIPE SUB-ASSEMBLY
23801L 9.INSTALL FUEL FILTER TO INJECTION PUMP FUEL PIPE SUB-ASSEMBLY
23765 10.INSTALL NO. 5 NOZZLE LEAKAGE PIPE
23812D 11.INSTALL NO. 2 FUEL PIPE
12.INSTALL INJECTION PIPE LH
13.INSTALL INJECTION PIPE RH
82121 14.CONNECT ENGINE WIRE
23243C 15.INSTALL FUEL PUMP MOTOR WIRE
44761 16.INSTALL VACUUM PUMP TO CONNECTOR TUBE
23271H 17.CONNECT NO. 1 AND NO. 2 FUEL HOSES
12142 18.INSTALL NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE
15301 19.INSTALL ENGINE OIL LEVEL DIPSTICK
17113 20.INSTALL INTAKE PIPE
Install a new gasket to the No. 3 intake manifold.
Temporarily install the intake pipe with the 4 bolts and 2 nuts.
Connect the No. 3 intercooler support bracket to the intake pipe with the 2 bolts.
Connect the vacuum hose to the intake pipe.
Attach the 3 wire harness clamps and connect the wire harness.
Connect the 2 ground wires with the 2 bolts.
23763 21.INSTALL NO. 3 NOZZLE LEAKAGE PIPE
25624 22.INSTALL EGR VALVE ADAPTER
Install a new gasket to the EGR valve adapter.
Make sure that the claw of the gasket faces the EGR valve adapter.
Temporarily install the EGR valve adapter with the 2 bolts.
23706 23.INSTALL NO. 6 INJECTION PIPE SUB-ASSEMBLY
16288 24.INSTALL NO. 4 WATER BY-PASS PIPE
25850 25.INSTALL ELECTRIC VACUUM REGULATING VALVE ASSEMBLY
25800 26.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY
Install a new gasket to the No. 4 EGR pipe.
Make sure that the claw of the gasket faces the No. 4 EGR pipe.
Temporarily install the electric EGR control valve assembly, No. 4 EGR pipe and 2 new gaskets with the 5 bolts.
Tighten the 4 bolts labeled A.
Tighten the 2 nuts labeled B.
Tighten the 2 bolts labeled C.
Tighten the 3 bolts labeled D.
Tighten the 2 bolts labeled E.
Connect the No. 9 water by-pass hose and No. 12 water by-pass hose to the electric EGR control valve assembly, and slide the 2 clamps to secure the 2 hoses.
Connect the connector.
26100G 27.INSTALL DIESEL THROTTLE BODY ASSEMBLY
28.ADD ENGINE COOLANT
29.BLEED AIR FROM FUEL SYSTEM
30.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
31.INSPECT FOR FUEL LEAK
32.INSPECT FOR OIL LEAK
33.INSPECT FOR COOLANT LEAK
51442 34.INSTALL NO. 2 ENGINE UNDER COVER