1.INSTALL FUEL SENDER GAUGE ASSEMBLY
If an fuel sender gauge assembly is removed from the fuel tank assembly, replace the fuel sender gauge assembly with a new one.
Install a new fuel sender gauge assembly with the 5 screws.
Attach the wire harness clamp to the fuel tank assembly.
for Model Code #J76 Series:
Attach the wire harness clamp to the frame.
for Model Code #J76 Series:
Connect the fuel sender gauge connector.
77100 2.INSTALL FUEL TANK ASSEMBLY (for Model Code #J79 Series)
58325E 3.INSTALL REAR FLOOR SERVICE HOLE COVER (for Model Code #J76 Series)
Install the rear floor service hole cover with the 2 screws.
4.BLEED AIR FROM FUEL SYSTEM
5.INSPECT FOR FUEL LEAK