The vacuum regulating valve (VRV) is controlled by the ECM with the duty control. According to the engine state, the VRV controls the vacuum applied to the actuator, which is installed to the turbocharger. If an open or short malfunction occurs in the VRV circuit, this DTC is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0045 | Turbocharger / Supercharger Boost Control Solenoid Circuit / Open | Open or short in vacuum regulating valve (VRV) circuit for 0.5 seconds or more (1 trip detection logic) |
·
Vacuum regulating valve (VRV)
·
Open or short in VRV circuit
·
ECM |
Comes on | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0045 | Ignition switch ON for 1 second |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR System)>REGISTRATION) and initialization(See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR System)>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Inspect the Vacuum Regulating Valve (VRV).
Click hereEngine / Hybrid System>1VD-FTV (EMISSION CONTROL)>VACUUM REGULATING VALVE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the vacuum regulating valve connector.
| *a | Front view of wire harness connector (to Vacuum Regulating Valve) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| C91-1 - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the vacuum regulating valve connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C91-2 - C39-85 (VN) | Always | Below 1 Ω |
| C91-2 or C39-85 (VN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the VRV connector.
Remove the MAIN2 relay from the engine room relay block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C91-1 - MAIN2 relay terminal 3 | Always | Below 1 Ω |
| C91-1 or MAIN2 relay terminal 3 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR System)>ECM Power Source Circuit
NG