Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C006328  Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure  C006396  Yaw Rate Sensor Component Internal Failure  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system.

The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

If there is trouble in the bus lines between the acceleration sensor (airbag ECU assembly) and the CAN communication system, DTCs U012587 are set.

These DTCs are also output when calibration has not been completed.

DTC No. Detection Item DTC Detection Condition Trouble Area
C006328 Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure With the vehicle stationary, the yaw rate sensor output value is not 0°/s. Acceleration sensor (Airbag ECU assembly)
C006396 Yaw Rate Sensor Component Internal Failure When the +BS terminal voltage is from 9.5 to 17.4 V, a data malfunction signal is received from the yaw rate sensor. Yaw rate sensor (Airbag ECU assembly)

CAUTION / NOTICE / HINT

NOTICE:

If the yaw rate and acceleration sensor (airbag ECU assembly) was replaced or reinstalled, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION


HINT:

When U012587 and/or U012687 is output together with C006328 and/or C006396, inspect and repair the trouble areas indicated by U012587 and/or U012687 first.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>U007488


PROCEDURE

1.REPLACE AIRBAG ECU ASSEMBLY
a.

Replace the airbag ECU assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL

HINT:

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
NEXT



NEXT

END