Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C052C1C  ABS Pump Motor Control Circuit Voltage Out of Range  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C052C1C ABS Pump Motor Control Circuit Voltage Out of Range When the +BS terminal voltage is from 9.5 to 17.4 V with the motor relay and motor fail-safe relay OFF, open or short in motor circuit continues for 2 seconds or more. Brake actuator assembly (Motor circuit)

C052C1C DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition When the +BS terminal voltage is from 9.5 to 17.4 V ○ ○
Malfunction Status With the motor relay and motor fail-safe relay OFF, open in motor circuit continues ○ -
With the motor relay and motor fail-safe relay OFF, short in motor circuit continues - ○
Detection Time 2 seconds or more. 2 seconds or more.
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)
C494113C02
1.49,0.073 1.917,0.313 0.427,0.24 0.583,1.24 0.594,1.792 true 0.438,1.865 1.052,2.063 0.615,0.198 10 false GND2 0.094,0.104 0.406,0.302 0.313,0.198 10 false *a 1.583,0.104 2.042,0.302 0.458,0.198 10 false A45
*a Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])


a.

Turn the ignition switch off.


b.

Make sure that there is no looseness at the locking part and the connecting part of the connectors.


c.

Disconnect the A45 skid control ECU (brake actuator assembly) connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A45-30 (GND2) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)