| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P277113 | Four Wheel Drive (4WD) Low Switch Circuit Open | No signal is input to the EXI4 terminal of the skid control ECU. |
·
L4 position switch (No. 1 transfer indicator switch)
·
L4 position switch (No. 1 transfer indicator switch) circuit
·
Skid control ECU (Brake actuator assembly) |
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Shift the transfer to L4, and then drive the vehicle.
Turn the ignition switch off.
Disconnect the A29 ECM connector.
Disconnect the A45 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45-23 (EXI4) - Body ground | Transfer shifted to L4 | Below 1 Ω |
| A45-15 (HDSC) - Body ground | Transfer shifted to L4 | Below 1 Ω |
Reconnect the A45 skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
Shift the transfer to H2 or H4, and then drive the vehicle.
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45-23 (EXI4) - Body ground | Transfer shifted to H2 or H4 | 10 kΩ or higher |
| A45-15 (HDSC) - Body ground | Transfer shifted to H2 or H4 | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Reconnect the A45 skid control ECU (brake actuator assembly) connector.
Reconnect the A29 ECM connector.
Turn the ignition switch to ON.
Clear the DTCs.
Turn the ignition switch off.
Start the engine.
Shift the transfer to H2 or H4.
Shift the transfer to L4, drive the vehicle, and then check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Disconnect the C36 L4 position switch (No. 1 transfer indicator switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45-23 (EXI4) - C36-2 | Always | Below 1 Ω |
| A45-15 (HDCS) - C36-2 | Always | Below 1 Ω |
| A45-23 (EXI4) - Body ground | Always | 10 kΩ or higher |
| A45-15 (HDCS) - Body ground | Always | 10 kΩ or higher |
| C36-2 - Body ground | Always | 10 kΩ or higher |
| C36-1 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the L4 position switch (No. 1 transfer indicator switch).
Click hereDrivetrain>HF1A (TRANSFER / 4WD / AWD)>TRANSFER INDICATOR SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG