Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  Slip Indicator Light Remains ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

The slip indicator light blinks during VSC and/or TRC operation.

If a malfunction is detected, the slip indicator light comes on to warn the driver.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>DIAGNOSIS SYSTEM

w/ Rear Differential Lock:

When the rear differential cannot be unlocked for 2 consecutive trips, the slip indicator light illuminates.

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION

·

w/ Rear Differential Lock:

As there may be malfunctions in the differential system related to when the system operates with the rear differential locked, check the differential system first.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>PROBLEM SYMPTOMS TABLE



PROCEDURE

1.CHECK VEHICLE CONTROL HISTORY
a.

Using the GTS, check for Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55
HINT:

If vehicle control history is stored (X204C, X2079, X2088, X208A, X20D7, X20D8 and X215A), the slip indicator light illuminates.



Result:
Result Proceed to
No vehicle control history (X204C, X2079, X2088, X208A, X20D7, X20D8 and X215A) A
Vehicle control history exists (X204C, X2079, X2088, X208A, X20D7, X20D8 and X215A) B



A

2.INSPECT COMBINATION METER ASSEMBLY

B

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>VEHICLE CONTROL HISTORY (RoB)

NOTICE:

After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.



2.INSPECT COMBINATION METER ASSEMBLY
a.

Perform Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Slip
50004 122 16

b.

Check the combination meter assembly.

OK:

The slip indicator light turns on or off in accordance with the GTS.



Result:
Proceed to
OK
NG



OK

NG