Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C007800  Different Diameter Tire  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C007800 Different Diameter Tire The vehicle speed exceeds 20 km/h (12 mph) and a difference exceeding 20% between the value output from the speed sensors of the front wheels and the rear wheels occurs the specified number of times or more.
·

Incorrect tire size

·

Tire air pressure not adjusted correctly

·

Speed sensor system

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION


PROCEDURE

1.CHECK TIRE SIZE
a.

Check the tire sizes to ensure that the front and rear tire sizes are not different.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION

HINT:

If different tire sizes are discovered, replace the tires so that the tire sizes are the same on all 4 wheels.



b.

Adjust the air pressure in the tires.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION


Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC
a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435

b.

Turn the ignition switch off.


c.

Start the engine.


d.

Drive the vehicle at a constant speed of 30 km/h (19 mph) or higher for several minutes.


e.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435

f.

Check that no vehicle stability control system speed sensor DTCs are output.

Chassis > Brake/EPB > Trouble Codes
50001 435
HINT:
·

If C007800 and vehicle stability control system DTCs are output simultaneously, check and repair the trouble areas in the vehicle stability control system.

·

When a DTC has been stored, the vehicle condition when the DTC was stored can be determined from the freeze frame data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>FREEZE FRAME DATA



Result:
Result Proceed to
DTCs are not output A
Vehicle stability control system speed sensor DTCs are output B
Only C007800 is output C




A

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

C