Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C124000  Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A"  


DESCRIPTION

The airbag sensor with ECU assembly has a built-in yaw rate and acceleration sensor.

If the identification ID of the yaw rate and acceleration sensor (airbag ECU assembly) is different to that stored in the skid control ECU (brake actuator assembly), this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C124000 Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A" The yaw rate and acceleration sensor (airbag ECU assembly) identification information stored in the skid control ECU (brake actuator assembly) is not consistent with the yaw rate and acceleration sensor (airbag ECU assembly) identification information sent via CAN communication continuously for 1 second or more.
·

Incorrect yaw rate and acceleration sensor (airbag ECU assembly) installed

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION

·

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION



PROCEDURE

1.CHECK PART NUMBER (AIRBAG ECU ASSEMBLY)
a.

Check that the part number of the installed yaw rate and acceleration sensor (airbag ECU assembly) is correct.

OK:

Yaw rate and acceleration sensor (airbag ECU assembly) installed in the vehicle has the correct part number.



Result:
Proceed to
OK
NG



OK

2.CLEAR DTC

NG

2.CLEAR DTC
a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435

b.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


b.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
C124000 is not output A
C124000 is output B



A

B