Home › Engine / Hybrid System › 1VD-FTV (STARTING) › GLOW PLUG › from 2022.09
RM25T0E _51 Engine / Hybrid System _029900 1VD-FTV STARTING _0137001 GLOW PLUG A

1VD-FTV STARTING  GLOW PLUG  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/ DPF:

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.

Click hereEngine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM (w/ DPF)>ON-VEHICLE INSPECTION



PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.

Clean the glow plug assembly and glow plug hole.


b.
A263013C01
0.934,1.385 1.117,1.536 0.183,0.151 10 *a
*a 12 Thread Roots


Apply adhesive to 3 or more thread roots in the area shown in the illustration.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Using a 10 mm deep socket wrench, install the 8 glow plug assemblies.

Torque:
12.3 N*m (125 kgf*cm, 9 ft.*lbf)


Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the 2 No. 1 glow plug connectors by uniformly tightening the 8 nuts.

Torque:
2.2 N*m (22 kgf*cm, 19 in.*lbf)


b.

Install the 8 glow plug screw grommets.


c.

Connect the 2 wire harnesses with the 2 nuts and 2 glow plug screw grommets.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART