DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are output by the blinking of the SRS warning light.
When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
A DTC output mode signal is transmitted through the CAN communication system to each ECU, including the airbag sensor assembly. Thus, when all systems do not enter DTC output mode, there may be a ECM malfunction.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting and reconnecting the battery
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
After replacing the airbag sensor assembly, refer to initialization.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
Check if a CAN communication DTC is output.
for LHD with VSC: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with VSC)>DIAGNOSIS SYSTEM
for RHD with VSC: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with VSC)>DIAGNOSIS SYSTEM
w/ Pre-collision System: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Pre-collision System)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are output (for LHD with VSC) | A |
| DTCs are output (for RHD with VSC) | B |
| DTCs are output (w/ Pre-collision System) | C |
| DTC is not output | D |
A
B
C
D
| *A | for RHD |
| *B | for LHD |
| *a | Front view of wire harness connector (to ECM) |
| *b | Front view of DLC3 |
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-13 (TC) - A29-27 (TC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-13 (TC) - I84-27 (TC) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of DLC3 |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-4 (CG) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for RHD |
| *B | for LHD |
| *a | Front view of wire harness connector (to ECM) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A29-27 (TC) - Body ground | Always | 10 MΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I84-27 (TC) - Body ground | Always | 10 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG