23810A 1.INSTALL COMMON RAIL LH
Install the common rail LH with the 2 bolts.
23765 2.INSTALL NO. 5 NOZZLE LEAKAGE PIPE
Install a new gasket and the No. 5 nozzle leakage pipe to the common rail LH with the union bolt.
Make sure there is no foreign matter or damage on the seal surface.
23239D 3.INSTALL NO. 1 FUEL HOSE
| *a | Marking |
Install the No. 1 fuel hose to the No. 5 nozzle leakage pipe and No. 5 fuel pipe sub-assembly, and slide the 2 clamps to secure the hoses.
Align the markings and connect the fuel hose.
Align the pinching portion of the clamp with the hose marking and connect the fuel hose.
23820A 4.INSTALL COMMON RAIL RH
Install the common rail RH with the 2 bolts.
Connect the fuel pressure sensor connector.
| *a | Torque Wrench Fulcrum Length |
Using a 17 mm union nut wrench, tighten the union nut on the common rail RH.
34 N*m (347 kgf*cm, 25 ft.*lbf)
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.1811 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 29.1 N*m (297 kgf*cm, 21 ft.*lbf)
23706 5.INSTALL NO. 6 INJECTION PIPE SUB-ASSEMBLY
6.INSTALL INJECTION PIPE
17940D 7.INSTALL INTERCOOLER ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9.ADD ENGINE COOLANT
10.BLEED AIR FROM FUEL SYSTEM
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
12.INSPECT FOR FUEL LEAK
13.INSPECT FOR OIL LEAK
14.INSPECT FOR COOLANT LEAK