| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BENCH TYPE REAR SEAT CUSHION ASSEMBLY | - | ( )
|
- | - |
| 2 | REAR SEAT CUSHION LOCK HOOK | 72693 | - | - | - |
| ● | Non-reusable part | - | - |
| *A | w/ Seat Heater System | - | - |
| *1 | REAR NO. 2 SEAT WIRE | - | - |
Move both front seats to the frontmost position and fold them forward.
72693
2.REMOVE REAR SEAT CUSHION LOCK HOOK
87510Q
5.REMOVE SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)
Use the same procedure described for the RH Side.
71503A
6.REMOVE REAR SEAT CUSHION PAD SUB-ASSEMBLY (OCCUPANT DETECTION SENSOR)
Disconnect the 3 connectors and remove the rear No. 2 seat wire from the rear seat cushion pad sub-assembly (occupant detection sensor).
Do not remove the occupant detection sensor from the rear seat cushion pad sub-assembly.