Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM37H0E _58 Vehicle Interior _095297 SEAT BELT _0448149 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B608084N01
0.583,0.448 6.635,3.667 6.052,3.219 6.115,0.229 6.802,0.229 false 1.469,0.854 1.885,0.854 1.885,0.854 1.885,1.24 false 4.615,2.969 5.354,2.969 false 1.438,3.271 1.438,3.021 1.438,3.021 1.781,2.896 false 5.854,1.458 5.854,1.052 5.854,1.052 6.125,1.052 false 3.74,0.177 3.458,0.177 3.458,0.177 3.458,0.438 false 5.958,0.083 6.24,0.438 0.281,0.354 18 false 1 3.781,0.052 4.063,0.406 0.281,0.354 18 false 2 1.458,3.292 1.74,3.646 0.281,0.354 18 false 4 6.167,0.917 6.448,1.271 0.281,0.354 18 false 3 1.229,0.719 1.51,1.073 0.281,0.354 18 false 5 5.729,2.823 6.01,3.177 0.281,0.354 18 false 6

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT SEAT ASSEMBLY RH - - - -
3 FRONT SEAT INNER BELT ASSEMBLY RH 73230 - - -
4 FRONT SEAT FRONT CUSHION SHIELD RH 71867V (Click here) - -
5 FRONT SEAT CUSHION SHIELD RH 71811D (Click here) - -
6 FRONT INNER SEAT CUSHION SHIELD RH 71861 (Click here) - -

B608367N01
0.083,0.156 3.833,2.75 3.75,2.594 0.167,1.167 3.333,1.802 3.167,0.635 5.063,3.135 5.063,2.5 false 0.813,3.188 0.813,2.76 false 0.948,2.188 1.375,2.188 false 1.042,1.563 1.76,1.563 false 0.948,0.646 1.375,0.646 false 2.563,3.094 2.99,3.094 false 5.115,3.167 5.448,3.49 0.333,0.323 18 false 7 0.719,3.208 1.052,3.531 0.333,0.323 18 false 8 0.615,2.031 0.948,2.354 0.333,0.323 18 false 10 0.688,1.417 1.021,1.74 0.333,0.323 18 false 11 0.781,0.552 1.094,0.75 0.313,0.198 10 false *1 0.583,1.448 0.896,1.646 0.313,0.198 10 false ● 6.052,2.594 6.365,2.792 0.313,0.198 10 false x 4 3.323,2.927 3.656,3.25 0.333,0.323 18 false 9 0.552,2.094 0.865,2.292 0.313,0.198 10 false ● 0.229,1.219 0.604,1.458 0.375,0.24 12 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

7 FRONT SEATBACK ASSEMBLY RH - (Click here) - -
8 SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH - - - -
9 CONNECTOR HOLDER 82667D (Click here) - -
10 SEPARATE TYPE FRONT SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR) 71511S (Click here) - -
11 FRONT SEAT CUSHION HEATER ASSEMBLY RH 87510K - - -

*A w/ Seat Heater System - -
*1 SEPARATE TYPE FRONT SEAT CUSHION COVER RH - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the occupant detection sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

(Click here)



Hide 2.REMOVE FRONT SEAT ASSEMBLY RH

a.

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY>REMOVAL


Hide 73230 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH

Hide 71867V 4.REMOVE FRONT SEAT FRONT CUSHION SHIELD RH

Z101186

HINT:

Use the same procedure described for the LH side.

(Click here)



Hide 71811D 5.REMOVE FRONT SEAT CUSHION SHIELD RH

Z101186

(Click here)

Hide 71861 6.REMOVE FRONT INNER SEAT CUSHION SHIELD RH

Z101186

(Click here)

Hide 7.REMOVE FRONT SEATBACK ASSEMBLY RH

Z101186

HINT:

Use the same procedure described for the LH side.

(Click here)



Hide 8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH

a.

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY>DISASSEMBLY


Hide 82667D 9.REMOVE CONNECTOR HOLDER

Z101186

(Click here)

Hide 71511S 10.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR)

Z101186

NOTICE:

Be careful not to dirty or damage the separate type front seat cushion cover RH and the separate type front seat cushon pad RH.



a.
B608094C01
2.271,1.323 3.135,1.24 true 0.396,0.052 0.677,0.406 0.281,0.354 18 false i 2.073,1.219 2.385,1.417 0.313,0.198 10 false *a
*a Band - -
V113147

Remove in this Direction - -


i.

Detach the band.



b.
B604710N01
0.49,0.125 0.771,0.479 0.281,0.354 18 false i

i.

Using a thin-bladed screwdriver, detach the claw to remove the separate type front seat cushion cover RH from the separate type front seat cushion pad RH as shown in the illustration.

HINT:

Tape the thin-bladed screwdriver tip before use.




Hide 87510K 11.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH (w/ Seat Heater System)

Z101186

HINT:

Use the same procedure described for the LH side.

(Click here)