| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | OUTER MIRROR LH | 87961 | ( )
|
- | - |
| 2 | NO. 2 OUTER MIRROR COVER LH | 8794A | ( )
|
- | - |
| 3 | OUTER MIRROR LIGHT ASSEMBLY LH | 81890D | ( )
|
- | - |
| *A | w/o Advanced Park | *B | w/ Advanced Park |
| *1 | VISOR COVER A | *2 | VISOR COVER B |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the outer mirror light assembly removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81890D
3.REMOVE OUTER MIRROR LIGHT ASSEMBLY LH
| *A | w/o Advanced Park | - | - |
Detach the claw and guide, then remove the outer mirror light assembly LH.
Detach the grommet and disconnect the connector.
| *A | w/ Advanced Park | - | - |
Detach the claw, wire harness clamp and guide, then remove the outer mirror light assembly LH.
Detach the grommet and disconnect the connector.