| *A | for Driver Side | *B | for Front Passenger Side |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 9 | FRONT SEAT HEADREST SUPPORT | 71931 | - | - | - |
| 10 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH | - | - | - | - |
| 11 | FRONT SEAT AIRBAG ASSEMBLY LH | 73920A | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat airbag assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH
73920A
11.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH
|
|