Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448370 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B605607N01
0.406,0.469 3.375,1.615 2.969,1.146 1.875,1.625 1.875,0.479 false 2.354,1.479 2.646,1.479 2.646,1.479 2.865,1.146 true 0.604,4.073 1.01,4.073 true 3.719,3.771 3.385,3.771 3.385,3.771 3.083,3.198 true 1.542,2.177 1.219,2.177 true 5.458,2.313 5.135,2.313 false 6.854,0.208 6.5,0.208 false 6.823,0.594 6.5,0.594 false 4.083,2.229 3.615,2.229 false 0.698,1.479 0.958,1.479 0.958,1.479 1.188,1.177 true 1.427,4.479 1.74,4.677 0.313,0.198 10 false x 2 2.094,2.76 2.406,2.958 0.313,0.198 10 false x 3 0.458,0.563 0.771,0.76 0.313,0.198 12 false *A 1.948,0.552 2.26,0.75 0.313,0.198 12 false *B 6.281,0.063 6.563,0.417 0.281,0.354 18 false 1 6.313,0.469 6.594,0.823 0.281,0.354 18 false 2 1.031,2.031 1.313,2.385 0.281,0.354 18 false 3 2.167,1.333 2.448,1.688 0.281,0.354 18 false 5 0.521,1.333 0.802,1.688 0.281,0.354 18 false 4 0.427,3.948 0.708,4.302 0.281,0.354 18 false 6 3.802,3.646 4.083,4 0.281,0.354 18 false 7 3.417,2.094 3.698,2.448 0.281,0.354 18 false 8

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 69284C - - -
4 POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL - - - -
5 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL - - - -
6 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 67602 - - -
7 FRONT DOOR SERVICE HOLE COVER LH 67832 - - -
8 SIDE AIRBAG PRESSURE SENSOR ASSEMBLY LH 8983AA (Click here) - -

*A for Driver Side *B for Front Passenger Side

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the side airbag pressure sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Hide 69284C 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 67602 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67832 7.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 8983AA 8.REMOVE SIDE AIRBAG PRESSURE SENSOR ASSEMBLY LH

a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B605608N01
1.833,1.406 2.031,1.708 0.198,0.302 18 true i 1.906,0.333 2.104,0.635 0.198,0.302 18 true ii 6.083,1.135 6.292,1.438 0.208,0.302 18 true iii

i.

Remove the nut.


ii.

Detach the claw and pull out the side airbag pressure sensor assembly LH.

NOTICE:

If the side airbag pressure sensor assembly LH has been dropped, replace it with a new one.



iii.

Disconnect the airbag connector and remove the side airbag pressure sensor assembly LH.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR