Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2020.11–2021.08
RM37H0E _59 Vehicle Exterior _093353 LIGHTING (EXT) _0448416 LIGHTING SYSTEM C

LIGHTING (EXT)  LIGHTING SYSTEM  B2452  Abnormal Height Sensor Data at Initialization  


DESCRIPTION

The headlight ECU sub-assembly LH stores this DTC if the value from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH, such as when the vehicle is not level or jacked up.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
B2452 Abnormal Height Sensor Data at Initialization
Detection condition:

Ignition switch ON


Malfunction status:

Abnormal rear height control sensor sub-assembly LH value detected during initialization


Malfunction duration:

-


·

Vehicle condition when initializing

·

Rear height control sensor sub-assembly LH

·

Harness or connector

·

Headlight ECU sub-assembly LH


AFS A w/ Adaptive High Beam System

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
B2452 Abnormal Height Sensor Data at Initialization
Detection condition:

Ignition switch ON


Malfunction status:

Abnormal rear height control sensor sub-assembly LH value detected during initialization


Malfunction duration:

-


·

Vehicle condition when initializing

·

Rear height control sensor sub-assembly LH

·

Harness or connector

·

Headlight ECU sub-assembly LH


HL AutoLeveling A w/o Adaptive High Beam System

WIRING DIAGRAM

E457065E02
1.365,2.583 1.677,2.781 0.313,0.198 10 false W5 1.365,2.771 3.01,3.667 1.646,0.896 10 false Rear height control sensor sub-assembly LH 2.396,0.99 2.854,1.188 0.458,0.198 10 false SHB 2.802,0.865 2.958,1.063 0.156,0.198 10 false 3 2.302,1.49 2.917,1.688 0.615,0.198 10 false SHRL 2.813,1.375 2.969,1.573 0.156,0.198 10 false 2 2.365,2.021 2.823,2.219 0.458,0.198 10 false SHG 2.823,1.875 2.979,2.073 0.156,0.198 10 false 1 4.323,1.104 4.781,1.302 0.458,0.198 10 false SBR 4.333,1.625 4.948,1.823 0.615,0.198 10 false SHRL 4.333,2.146 4.792,2.344 0.458,0.198 10 false SHG 4.115,2.781 6.594,3.115 2.479,0.333 10 false Headlight ECU sub-assembly LH 4.115,2.542 4.427,2.74 0.313,0.198 10 false A26 4.948,0.74 5.26,0.938 0.313,0.198 10 false 5 V 4.031,0.854 4.344,1.052 0.313,0.198 10 false 16 4.031,1.375 4.344,1.573 0.313,0.198 10 false 17 4.042,1.875 4.354,2.073 0.313,0.198 10 false 15

CAUTION / NOTICE / HINT

NOTICE:
·

If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION

·

After the rear height control sensor sub-assembly LH is replaced or removed and installed, initialization is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION



PROCEDURE

1.INITIALIZATION HEADLIGHT ECU SUB-ASSEMBLY LH
a.

Perform initialization of the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK VEHICLE TYPE
2.CHECK VEHICLE TYPE
a.

Check vehicle condition.


Result:
Result Proceed to
w/ Adaptive High Beam System A
w/o Adaptive High Beam System B



A

3.CLEAR DTC

B

8.CLEAR DTC
3.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Body Electrical > AFS > Clear DTCs
50002 165
Result:
Proceed to
NEXT



Post-procedure1

a.

None



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC

Pre-procedure1

a.

Turn the ignition switch ON.


Procedure1

a.

Check for DTCs.

Body Electrical > AFS > Trouble Codes
50001 165
Result:
Result Proceed to
B2452 is not output A
B2452 is output B



Post-procedure1

a.

None



A

B

5.CHECK REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
5.CHECK REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
a.

Check the rear height control sensor sub-assembly LH installation condition.

HINT:

Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSTALLATION


OK:

Rear height control sensor sub-assembly LH installation condition is normal.



Result:
Proceed to
OK
NG



OK

6.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

NG

6.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

OK

7.CHECK HARNESS AND CONNECTOR (HEADLIGHT ECU SUB-ASSEMBLY LH - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH)

NG

REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

7.CHECK HARNESS AND CONNECTOR (HEADLIGHT ECU SUB-ASSEMBLY LH - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH)

Pre-procedure1

a.

Disconnect the A26 headlight ECU sub-assembly LH connector.


b.

Disconnect the W5 rear height control sensor sub-assembly LH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(A26,W5)Location & Routing

Click Connector(A26)Engine Compartment>Front Compartment Main Wire / No. 3 Front Compartment Wire / No. 4 Front Compartment Wire>Headlight ECU Sub-Assembly LH

Click Connector(W5)Body>Rear Skid Control Sensor Wire LH / Rear Skid Control Sensor Wire RH>Rear Height Control Sensor Sub-Assembly LH

A26-16 (SBR) - W5-3 (SHB) Always Below 1 Ω
A26-17 (SHRL) - W5-2 (SHRL) Always Below 1 Ω
A26-15 (SGR) - W5-1 (SHG) Always Below 1 Ω
A26-16 (SBR) or W5-3 (SHB) - Body ground Always 10 kΩ or higher
A26-17 (SHRL) or W5-2 (SHRL) - Body ground Always 10 kΩ or higher
A26-15 (SGR) or W5-1 (SHG) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

8.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361
Result:
Proceed to
NEXT



Post-procedure1

a.

None



NEXT

9.CHECK FOR DTC
9.CHECK FOR DTC

Pre-procedure1

a.

Turn the ignition switch ON.


Procedure1

a.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
Result:
Result Proceed to
B2452 is not output A
B2452 is output B



Post-procedure1

a.

None



A

B

5.CHECK REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH