Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
67914B
1.REMOVE FRONT DOOR SCUFF PLATE LH
55471A
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
55606
4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55045
5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
84988L
6.REMOVE VSC OFF SWITCH
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the VSC OFF switch from the lower instrument panel finish panel sub-assembly as shown in the illustration.