Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall)
RM37H0E _56 Audio / Visual / Telematics _095262 TELEMATICS _0447865 TELEMATICS SYSTEM T

TELEMATICS  TELEMATICS SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

*: The availability of functions differs depending on the region and destination.



Manual (SOS) Switch Indicator Display Problem
Symptom Suspected Area Link
The manual (SOS) switch illumination does not illuminate Proceed to "Emergency Call Switch Illumination Circuit" Click here
The manual (SOS) switch indicator (red) illuminates after the ignition switch is turned to ON Proceed to "DIAGNOSTIC TROUBLE CODE CHART" Click here
Proceed to "VEHICLE CONTROL HISTORY" Click here

Alarm Notification Function
Symptom Suspected Area Link
When the theft deterrent system is activated, the service center is not informed of the alarm* Proceed to "Alarm Notification Function Malfunction" Click here

Remote Air Conditioning Function
Symptom Suspected Area Link
Air conditioning system does not start by remote air conditioning start function.* Cancel service mode (communication function pausing mode) Click here
Check that the air conditioning system is operating normally Click here
Use the GTS to check whether the service subscription is active. Click here
Proceed to "DCM Operation History" in Utility Click here

Remote Service Function
Symptom Suspected Area Link
The specific remote service cannot be used* Use the GTS to check whether the service subscription is active. Click here
Check that the meter / gauge system is operating normally Click here
Check that the entry and start system (for Entry Function) is operating normally Click here
Check that the theft deterrent system is operating normally Click here
Check that the lighting system (EXT) is operating normally Click here
Check that the lighting system (INT) is operating normally Click here
Check that the power window control system is operating normally Click here
Check that the power door lock control system is operating normally Click here
Proceed to "DCM Operation History" in Utility Click here
Contact service center -