| *A | for LHD | *B | for RHD |
| *C | for 3 Zone Type | *D | for Dual Type |
| *1 | for Dual Type | *2 | HEATER CASE (for Rear Side) |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Compressor oil ND-OIL 11 or equivalent | - | - |
88625
1.INSTALL NO. 1 COOLER THERMISTOR
| *a | Fixed Part | *b | Sensor Part |
Install the No. 1 cooler thermistor as shown in the illustration.
| Part | Length |
|---|---|
| A | 105 mm (4.13 in.)(16 Fins) |
| B | 45 to 55 mm (1.77 to 2.17 in.) |
Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.
When reusing the No. 1 cooler evaporator sub-assembly, insert the sensor part of the No. 1 cooler thermistor one row from the row that had been used previously (X in the illustration).
Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
87050C
3.INSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050D
4.INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
88710H
7.INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
88H92
8.INSTALL NO. 2 COOLER COVER
82210K
9.INSTALL AIR CONDITIONING HARNESS ASSEMBLY
87124C
11.INSTALL HEATER CLAMP
88536B
12.INSTALL NO. 3 COOLING UNIT BRACKET
88H99
13.INSTALL COOLING UNIT PARTS
87128
14.INSTALL HEATER GROMMET
87130D
15.INSTALL BLOWER ASSEMBLY