| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | OUTER MIRROR LH | - | ( )
|
- | - |
| 2 | NO. 2 OUTER MIRROR COVER LH | - | ( )
|
- | - |
| 3 | PARKING ASSIST LIGHT LH | 867A2A | ( )
|
- | - |
| *1 | OUTER MIRROR TAPE | *2 | CONNECTOR CLAMP |
| *3 | VISOR COVER A | *4 | VISOR COVER B |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the parking assist light LH removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
867A2A
3.REMOVE PARKING ASSIST LIGHT LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the outer mirror tape.
Pull in the direction of the arrow in the claw to remove the connector clamp.
Disconnect the connector.
Remove the 2 screws and parking assist light LH.