| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | FRONT SEATBACK ASSEMBLY LH | - | ( )
|
- | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH | - | - | - | - |
| 9 | FRONT SEAT WIRE LH | 82192 | - | - | - |
| 10 | LH SEAT RECLINING ADJUSTER INSIDE COVER LH | 71875G | ( )
|
- | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | POWER SEAT LIFTER MOTOR ASSEMBLY LH | 85822C | - | - | - |
| 12 | POWER SEAT TILT MOTOR ASSEMBLY LH | 85822B | - | - | - |
| *1 | FRONT SEAT VERTICAL HOUSING SUB-ASSEMBLY LH | *2 | VERTICAL ADJUSTER SPACER |
| *3 | FRONT SEAT ADJUSTER PLATE | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front power seat motor assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH
82192
9.DISCONNECT FRONT SEAT WIRE LH
85822C
11.REMOVE POWER SEAT LIFTER MOTOR ASSEMBLY LH
|
Remove in this Direction | - | - |
85822B
12.REMOVE POWER SEAT TILT MOTOR ASSEMBLY LH