| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | POWER SEAT TILT MOTOR ASSEMBLY LH | 85822B | ( )
|
- | - |
| 2 | POWER SEAT LIFTER MOTOR ASSEMBLY LH | 85822C | ( )
|
- | - |
| *1 | FRONT SEAT VERTICAL HOUSING SUB-ASSEMBLY LH | *2 | VERTICAL ADJUSTER SPACER |
| *3 | FRONT SEAT ADJUSTER PLATE | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | LH SEAT RECLINING ADJUSTER INSIDE COVER LH | 71875G | - | - | - |
| 4 | FRONT SEAT WIRE LH | 82192 | - | - | - |
| 5 | SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85822B
1.INSTALL POWER SEAT TILT MOTOR ASSEMBLY LH
|
|
85822C
2.INSTALL POWER SEAT LIFTER MOTOR ASSEMBLY LH
| *a | Stud Bolt of the Front Seat Vertical Housing Sub-assembly LH | *b | Hole of the Front Seat Adjuster Assembly LH |
| *c | Front Seat Vertical Housing Sub-assembly LH | *d | Front Seat Adjuster Assembly LH |
Install the front seat vertical housing sub-assembly LH.
Make sure to insert the stud bolt of the front seat vertical housing sub-assembly LH into the hole of the front seat adjuster assembly LH as shown in the illustration.
Make sure to position the front seat adjuster assembly LH so that when the front seat vertical housing sub-assembly LH is installed, their gears will be positioned as shown in the illustration.
Install the vertical adjuster spacer.
Install the front seat adjuster plate with the 3 nuts.
71875G
3.INSTALL LH SEAT RECLINING ADJUSTER INSIDE COVER LH
82192
4.CONNECT FRONT SEAT WIRE LH
5.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH
6.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH
71862
7.INSTALL FRONT INNER SEAT CUSHION SHIELD LH
71812D
8.INSTALL FRONT SEAT CUSHION SHIELD LH
71868N
9.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
11.INSTALL FRONT SEAT ASSEMBLY LH