Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY
RM37H0E _58 Vehicle Interior _095292 SEAT _0454731 LUMBAR SUPPORT ADJUSTER ASSEMBLY A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B608077N02
0.719,0.427 6.396,3.74 5.677,3.313 2.125,1.396 2.479,1.396 false 6.208,0.219 6.833,0.219 false 3.677,0.427 3.677,0.271 3.677,0.271 3.958,0.271 false 4.354,3.406 4.927,3.406 false 1.865,3.24 2.49,3.24 false 6.052,0.052 6.333,0.406 0.281,0.354 18 false 1 1.896,1.24 2.177,1.594 0.281,0.354 18 false 5 4.135,3.25 4.417,3.604 0.281,0.354 18 false 4 2.875,3.083 3.156,3.438 0.281,0.354 18 false 3 4.021,0.115 4.302,0.469 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT SEAT ASSEMBLY LH - - - -
3 FRONT SEAT FRONT CUSHION SHIELD LH 71868N (Click here) - -
4 FRONT SEAT CUSHION SHIELD LH 71812D (Click here) - -
5 FRONT INNER SEAT CUSHION SHIELD LH 71862 (Click here) - -

B607558N06
4.76,1.125 5.333,1.125 false 2.771,0.896 3.083,1.094 0.313,0.198 10 false x 4 5.708,0.979 6.01,1.24 0.302,0.26 18 false 6

Procedure Part Name Code
Z101186

Z101188

Z101187

6 FRONT SEATBACK ASSEMBLY LH - (Click here) - -

B608078N02
0.688,1.323 1.427,1.323 false 4.271,0.365 4.271,0.198 4.271,0.198 4.844,0.198 false 4.448,0.479 4.448,0.198 false 5.188,0.073 5.469,0.427 0.281,0.354 18 false 7 0.385,1.167 0.667,1.521 0.281,0.354 18 false 8

Procedure Part Name Code
Z101186

Z101188

Z101187

7 FRONT SEAT HEADREST SUPPORT 71931 (Click here) - -
8 SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH - - - -

B604459N02
0.167,0.74 2.073,3.052 1.906,2.313 2.198,0.74 3.177,3.042 0.979,2.302 0.542,2.531 0.542,1.958 false 1.396,2.635 1.396,2.375 false 2.573,2.646 2.573,2.385 false 6.24,2.979 6.24,2.719 false 3.271,3.375 3.271,2.813 false 3.281,3.271 3.625,3.271 3.625,3.271 3.625,3.01 false 0.26,0.813 0.635,1.052 0.375,0.24 12 false *A 2.26,0.813 2.635,1.052 0.375,0.24 12 false *B 2.51,2.677 2.813,2.979 0.302,0.302 18 false 9 1.365,2.646 1.667,2.948 0.302,0.302 18 false 9 6.115,3 6.417,3.302 0.302,0.302 18 false 10 0.417,2.531 0.719,2.833 0.302,0.302 18 false 11 3.229,3.385 3.531,3.688 0.302,0.302 18 false 12

Procedure Part Name Code
Z101186

Z101188

Z101187

9 LUMBAR SUPPORT ADJUSTER ASSEMBLY LH 72760D (Click here) - -
10 SEATBACK FELT 79977A - - -
11 SEATBACK CLIMATE CONTROL BLOWER RH 85867 - - -
12 FRONT SEATBACK EDGE PROTECTOR 71587 (Click here) - -

*A w/ Climate Control Seat System *B w/o Climate Control Seat System

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lumba support adjuster assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Front power seat control system (w/ Memory)
·

Front seat back frame sub-assembly LH (for LHD)*

·

Front seat back frame sub-assembly RH (for RHD)*

·

Front power seat adjuster assembly LH (for LHD)*

·

Front power seat adjuster assembly RH (for RHD)*


Initialize position control ECU Front power seat control system (w/ Memory) (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

(Click here)



Hide 2.REMOVE FRONT SEAT ASSEMBLY LH

Hide 71868N 3.REMOVE FRONT SEAT FRONT CUSHION SHIELD LH

Z101186

(Click here)

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD LH

Z101186

(Click here)

Hide 71862 5.REMOVE FRONT INNER SEAT CUSHION SHIELD LH

Z101186

(Click here)

Hide 6.REMOVE FRONT SEATBACK ASSEMBLY LH

Z101186

(Click here)

Hide 71931 7.REMOVE FRONT SEAT HEADREST SUPPORT

Z101186

(Click here)

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH

Hide 72760D 9.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

Z101186

HINT:
·

Remove the lumbar support adjuster assembly LH together with the 2 front seatback edge protectors and the seatback felt.

·

w/ Climate Control Seat System:

Remove the seatback climate control blower together.




a.
B608360C01
1.604,1.74 0.875,1.719 0.875,1.719 1.594,1.146 true 0.688,1.677 1,1.875 0.313,0.198 10 false *A
*A w/ Climate Control Seat System - -
V113147

Remove in this Direction - -



Hide 79977A 10.REMOVE SEATBACK FELT

Hide 85867 11.REMOVE SEATBACK CLIMATE CONTROL BLOWER RH (w/ Climate Control Seat System)

Hide 71587 12.REMOVE FRONT SEATBACK EDGE PROTECTOR

Z101186

(Click here)