| *A | for Driver Side | *B | for Front Passenger Side |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | FRONT SEATBACK ASSEMBLY LH | - | ( )
|
- | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 9 | FRONT SEAT HEADREST SUPPORT | 71931 | ( )
|
- | - |
| 10 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | SEPARATE TYPE FRONT SEATBACK COVER LH | 71074S | ( )
|
- | - |
| 12 | FRONT SEATBACK HEATER ASSEMBLY LH | 87510N | ( )
|
- | - |
| *1 | SEPARATE TYPE FRONT SEATBACK PAD LH | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seatback heater removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH
87510N
12.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH
Remove the tape and front seatback heater assembly LH.
Do not reuse the front seatback heater assembly LH.
If the front seatback heater assembly LH is removed from the separate type front seatback pad LH, replace the separate type front seatback pad LH with new one.