| *A | for Front Passenger Side | - | - |
| *1 | SEPARATE TYPE FRONT SEAT CUSHION PAD LH | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| *A | for Driver Side | *B | for Front Passenger Side |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87510L
1.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH
| *a | Area A | *b | Area B |
| *c | Area C | *d | Area D |
| *e | Area E | *f | Bridge Part |
| *g | Positioning Standard | - | - |
The following procedure is performed to install the front seat cushion heater assembly LH to separate type front seat cushion pad LH.
1. Remove the release paper of area A from the front seat cushion heater assembly LH and attach it to the separate type front seat sushion pad LH aligning with the positioning standard.
2. Remove the release paper of area B from the front seat cushion heater assembly LH and attach it to the separate type front seat sushion pad LH aligning with the positioning standard.
3. Remove the release paper of area C from the front seat cushion heater assembly LH and attach it to the separate type front seat sushion pad LH aligning with the positioning standard.
4. Remove the release paper of area D from the front seat cushion heater assembly LH and attach it to the separate type front seat sushion pad LH aligning with the positioning standard.
5. Remove the release paper of area E from the front seat cushion heater assembly LH and attach it to the separate type front seat sushion pad LH aligning with the positioning standard.
6. Insert 8 bridge parts of the front seat cushion heater assembly LH into the groove of the separate type front seat sushion pad LH.
After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves.
Do not reuse the front seat cushion heater assembly LH and separate type front seatback cover LH.
Apply pressure to paste the front seat cushion heater assembly LH to the separate type front seat cushion pad LH securely.
71072S
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER LH
82667D
3.INSTALL CONNECTOR HOLDER (for Front Passenger Side)
4.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH
5.INSTALL FRONT SEATBACK ASSEMBLY LH
71862
6.INSTALL FRONT INNER SEAT CUSHION SHIELD LH (for Driver Side)
71861
7.INSTALL FRONT INNER SEAT CUSHION SHIELD RH (for Front Passenger Side)
71812D
8.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71811D
9.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71868N
10.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
13.INSTALL FRONT SEAT ASSEMBLY LH