Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › AHS ECU
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0454816 AHS ECU A

ADVANCED DRIVER ASSISTANCE SYSTEM  AHS ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E473256N01
0.552,0.969 6.74,5.01 6.188,4.042 2.469,3.5 3.385,3.5 false 2.688,2.646 3.396,2.646 false 5.177,2.979 5.177,2.573 false 3.698,0.979 3.698,0.469 3.698,0.469 4.125,0.469 false 4.156,0.365 4.438,0.719 0.281,0.354 18 false 1 3.448,3.385 3.729,3.74 0.281,0.354 18 false 2 5.094,3.073 5.406,3.271 0.313,0.198 10 false *1 2.49,2.542 2.771,2.896 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 HEADLIGHT ASSEMBLY LH - - - -
2 HEADLIGHT LENS SUB-ASSEMBLY LH 8110B - - -
3 LIGHT CONTROL LED ECU LH 85967D (Click here) - -

*1 HEADLIGHT HOUSING SUB-ASSEMBLY LH - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the light control led ECU removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Front bumper assembly (Including removal and installation)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking assist- sensor system

·

Parking support brake system

·

Advanced park


w/ Advanced Park:
(Click here)
w/o Advanced Park:
(Click here)
Front television camera view adjustment Panoramic view monitor system (Click here)
Front television camera assembly, front bumper assembly or radiator grille
·

Television camera view adjustment

HINT:

Replacement or removal and installation of 2 or more parts



Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1.REMOVE HEADLIGHT ASSEMBLY LH

Hide 8110B 2.REMOVE HEADLIGHT LENS SUB-ASSEMBLY LH

Hide 85967D 3.REMOVE LIGHT CONTROL LED ECU LH

Z101292

NOTICE:
·

Prevention of static electricity is required during this procedure.

·

Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

·

Perform work using clean rubber gloves.

·

Do not touch the inner surface of the lens and metallic surfaces as much as possible, or they may become dirty.

·

Do not allow metallic surfaces to become dirty, as such surfaces become damaged even if they are only lightly wiped with a soft cloth.

·

Do not use solvent to clean components. Only clean them with a dry cloth.




SST
09890-47010  (09891-04020, 09891-04010, 09891-04030, 09891-04040)

a.
E463006C01
0,0 0,0 false
V100135

Connector
V100136

Screw