Home › Drivetrain › Q710 (HYBRID TRANSMISSION / TRANSAXLE) › ELECTRONIC SHIFT LEVER SYSTEM
RM37H0E _52 Drivetrain _093826 Q710 HYBRID TRANSMISSION / TRANSAXLE _0454877 ELECTRONIC SHIFT LEVER SYSTEM C

Q710 HYBRID TRANSMISSION / TRANSAXLE  ELECTRONIC SHIFT LEVER SYSTEM  P085D46  Gear Shift Control Module "A" Calibration / Parameter Memory Failure  P176949  Gear Shift Control Module "A" Internal Electronic Failure  P176B9F  Fail Safe Signal (Gear Shift Control Module "A") Stuck Off  


DESCRIPTION

The shift control ECU monitors its internal operation. When it detects an internal malfunction, the DTC is stored in the EV control ECU. If this DTC is stored, replace the shift control ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P085D46 Gear Shift Control Module "A" Calibration / Parameter Memory Failure ECU internal malfunction (data flush malfunction) retries 3 times or more continuously
(1 trip detection logic)
Shift control ECU
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV A
P176949 Gear Shift Control Module "A" Internal Electronic Failure ECU internal malfunction (AD timeout error) continuously occurs for 0.02 seconds or more
(1 trip detection logic)
Shift control ECU
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV A
P176B9F Fail Safe Signal (Gear Shift Control Module "A") Stuck Off ECU internal malfunction (SBFS circuit malfunction) continuously occurs for 0.5 seconds or more
(1 trip detection logic)
Shift control ECU
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV A

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

Click hereDrivetrain>Q710 (HYBRID TRANSMISSION / TRANSAXLE)>ELECTRONIC SHIFT LEVER SYSTEM>UTILITY


1.

Turn the ignition switch to ON (READY) and wait for 15 seconds or more.


CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with a shift control supply. Therefore, ensure there is no power being supplied to the vehicle when disconnecting or reconnecting the connector of the shift control ECU and when removing or installing the shift control ECU.

Click hereDrivetrain>Q710 (HYBRID TRANSMISSION / TRANSAXLE)>ELECTRONIC SHIFT LEVER SYSTEM>PRECAUTION


PROCEDURE

1.REPLACE SHIFT CONTROL ECU

NEXT

COMPLETED