Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0455055 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1455  Air Outlet Damper FOOT/DEF Control Servo Motor Circuit (Driver Side)  


DESCRIPTION

*1: for Dual

*2: for 3 Zone

*3: for LHD

*4: for RHD


The No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*3, No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*4 sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*3, No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*4 to the appropriate position, which controls the air outlet switching.

The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from Priority
B1455 Air Outlet Damper FOOT/DEF Control Servo Motor Circuit (Driver Side)
·

Diagnosis condition: During No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*3, No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*4 operation

·

Malfunction status: The damper servo operation request signal is output but the position information of the servo does not change or servo is malfunctioning

·

Detection time: Continuously for 30 seconds or more


·

No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*3

·

No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*4

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly


Memorized Air Conditioner B

DTC Diagnosis Condition Combination Table
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition During No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*3, No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT*1, driver side MODE FOOT*2)*4 operation ○ ○
Malfunction Status The damper servo operation request signal is output but the position information of the servo does not change ○ -
The damper servo operation request signal is output but the position information of the servo is malfunctioning - ○
Detection Time Continuously for 30 seconds or more Continuously for 30 seconds or more
Trip Count 1 trip 1 trip

HINT:

If the conditions match either of these patterns, a DTC will be output.


WIRING DIAGRAM

for LHD:
E459549E31
4.927,1.958 6.521,2.333 1.594,0.375 10 false Air Conditioning Amplifier Assembly 5.844,0.594 6.417,0.802 0.573,0.208 10 false IC 6.417,0.76 6.99,0.969 0.573,0.208 10 false +B 4.844,1.104 5.396,1.281 0.552,0.177 10 false BUS G 4.594,1.104 5.156,1.281 0.563,0.177 10 false 2 4.833,0.802 5.385,0.979 0.552,0.177 10 false B BUS 4.594,0.802 5.146,0.979 0.552,0.177 10 false 4 4.823,0.49 5.375,0.667 0.552,0.177 10 false BUS 4.594,0.417 5.146,0.594 0.552,0.177 10 false 3 4.927,1.802 5.375,1.979 0.448,0.177 10 false z1 0.021,1.677 3.135,2.208 3.115,0.531 10 false No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (MODE FOOT*1, Driver Side MODE FOOT*2) 3.229,1.75 4.76,2.177 1.531,0.427 10 false Air Conditioning Harness Assembly 0.729,2.396 3.156,2.594 2.427,0.198 10 false : LIN Communication Line 2.563,2.365 3.396,2.573 0.833,0.208 10 false *1: for Dual 3.365,2.354 4.302,2.573 0.938,0.219 10 false *2: for 3 Zone

for RHD:
E459549E32
4.927,1.958 6.521,2.333 1.594,0.375 10 false Air Conditioning Amplifier Assembly 5.844,0.594 6.417,0.802 0.573,0.208 10 false IC 6.417,0.76 6.99,0.969 0.573,0.208 10 false +B 4.844,1.104 5.396,1.281 0.552,0.177 10 false BUS G 4.594,1.104 5.156,1.281 0.563,0.177 10 false 2 4.833,0.802 5.385,0.979 0.552,0.177 10 false B BUS 4.594,0.802 5.146,0.979 0.552,0.177 10 false 4 4.823,0.49 5.375,0.667 0.552,0.177 10 false BUS 4.594,0.417 5.146,0.594 0.552,0.177 10 false 3 4.927,1.802 5.375,1.979 0.448,0.177 10 false z1 0.021,1.677 3.135,2.208 3.115,0.531 10 false No. 3 Air Conditioning Radiator Damper Servo Sub-assembly (MODE FOOT*1, Driver Side MODE FOOT*2) 3.229,1.729 4.76,2.156 1.531,0.427 10 false Air Conditioning Harness Assembly 0.729,2.396 3.156,2.594 2.427,0.198 10 false : LIN Communication Line 2.448,2.385 3.375,2.583 0.927,0.198 10 false *1: for Dual 3.365,2.385 4.292,2.583 0.927,0.198 10 false *2: for 3 Zone

CAUTION / NOTICE / HINT

NOTICE:
·

Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or the damper is mechanically locked.

·

When installing the damper servo motor, make sure to install it correctly.

·

When the servo motor is replaced, be sure to perform servo motor initialization.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>INITIALIZATION



HINT:

Confirm that no mechanical problem is present because this DTC can be output when either a damper link or damper is mechanically locked.


PROCEDURE

1.CHECK VEHICLE TYPE
Result:
Result Proceed to
for LHD A
for RHD B



A

2.CHECK FOR DTC

B

6.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B1455 is output A
B1455 and B1497 are output B



A

3.CHECK NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

B

3.CHECK NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
a.

Check for No. 1 air conditioning radiator damper servo sub-assembly is installed correctly.

OK:

No. 1 air conditioning radiator damper servo sub-assembly is installed correctly.



Result:
Proceed to
OK
NG



OK

4.CHECK NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)

NG

REINSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

4.CHECK NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)
a.

Check for a wire harness caught between the links of the motors and dampers.

OK:

No wire harnesses are caught between the links of the motors and dampers.



Result:
Proceed to
OK
NG



OK

5.CHECK AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

NG

REMOVE PINCHED NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

5.CHECK AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

Pre-procedure1

a.

Remove the No. 1 air conditioning radiator damper servo sub-assembly.

HINT:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT (for LHD)>DISASSEMBLY



Procedure1

a.

Operate the dampers by hand.

OK:

The dampers are easily operated by hand.



Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

REPLACE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

NG

REPAIR OR REPLACE AIR CONDITIONING RADIATOR ASSEMBLY

6.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B1455 is output A
B1455 and B1497 are output B



A

7.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

B

7.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
a.

Check for No. 3 air conditioning radiator damper servo sub-assembly is installed correctly.

OK:

No. 3 air conditioning radiator damper servo sub-assembly is installed correctly.



Result:
Proceed to
OK
NG



OK

8.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)

NG

REINSTALL NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

8.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)
a.

Check for a wire harness caught between the links of the motors and dampers.

OK:

No wire harnesses are caught between the links of the motors and dampers.



Result:
Proceed to
OK
NG



OK

9.CHECK AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

NG

REMOVE PINCHED NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

9.CHECK AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

Pre-procedure1

a.

Remove the No. 3 air conditioning radiator damper servo sub-assembly.

HINT:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT (for RHD)>DISASSEMBLY



Procedure1

a.

Operate the dampers by hand.

OK:

The dampers are easily operated by hand.



Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

REPLACE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

NG

REPAIR OR REPLACE AIR CONDITIONING RADIATOR ASSEMBLY