The No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FACE) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FACE) to the appropriate position, which controls the air outlet switching.
The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B1448 | Passenger Side FACE Servo Motor Circuit | Diagnosis condition:
During No. 6 air conditioning radiator damper servo sub-assembly operation Malfunction status:
The damper servo operation request signal is output but the position information of the servo does not change or servo is malfunctioning Detection time:
Continuously for 30 seconds or more |
·
No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FACE) ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
Memorized | Air Conditioner | B |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | During No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FACE) operation | ○ | ○ |
| Malfunction Status | The damper servo operation request signal is output but the position information of the servo does not change | ○ | - |
| The damper servo operation request signal is output but the position information of the servo is malfunctioning | - | ○ | |
| Detection Time | Continuously for 30 seconds or more | Continuously for 30 seconds or more | |
| Trip Count | 1 trip | 1 trip | |
If the conditions match either of these patterns, a DTC will be output.
*1: for LHD
*2: for RHD
Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or the damper is mechanically locked.
When installing the damper servo motor, make sure to install it correctly.
When the servo motor is replaced, be sure to perform servo motor initialization.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>INITIALIZATION
Confirm that no mechanical problem is present because this DTC can be output when either a damper link or damper is mechanically locked.
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1448 is output | A |
| B1448 and B1497 are output | B |
A
B
Check for No. 6 air conditioning radiator damper servo sub-assembly is installed correctly.
No. 6 air conditioning radiator damper servo sub-assembly is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for a wire harness caught between the links of the motors and dampers.
No wire harnesses are caught between the links of the motors and dampers.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Pre-procedure1
Remove the No. 6 air conditioning radiator damper servo sub-assembly.
Procedure1
Operate the dampers by hand.
The dampers are easily operated by hand.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG