Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37H0E _58 Vehicle Interior _095316 METER / GAUGE / DISPLAY _0455143 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Meter Illumination is Always Dark  


DESCRIPTION

The combination meter assembly receives signals from this circuit to adjust the illumination of the combination meter assembly. The combination meter assembly sets the illumination level based on the user operation of the light control rheostat switch.

WIRING DIAGRAM

E230682E33
1.115,1.646 2.76,2.021 1.646,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 4.313,1.708 6.177,1.938 1.865,0.229 10 false Combination Meter Assembly 1.208,2.365 2.979,2.542 1.771,0.177 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



HINT:
·

The meter illumination dims when the taillights are turned on.

·

Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.

·

Setting the meter illumination level to minimum brightness turns off the meter illumination.

·

The automatic light control sensor sensitivity can be customized.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS



PROCEDURE

1.CHECK FOR DTC
a.

Check if lighting system DTCs are output.

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Result Proceed to
DTC B1244 is not output. A
DTC B1244 is output. B



A

2.CHECK COMBINATION METER ASSEMBLY

B

2.CHECK COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly with a new one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


OK:

The operation of the combination meter assembly returns to normal.


Result:
Proceed to
OK
NG



OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)