Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37H0E _58 Vehicle Interior _095316 METER / GAUGE / DISPLAY _0455143 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Meter Illumination does not Dim at Night  


DESCRIPTION

In this circuit, the combination meter assembly receives auto dimmer signals from the main body ECU (multiplex network body ECU) via CAN communication. When the combination meter assembly receives an auto dimmer signal, it dims the meter illumination (warning and indicator lights).

The main body ECU (multiplex network body ECU) determines whether it is daytime or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU (multiplex network body ECU) determines that it is nighttime and the headlight dimmer switch assembly is in the tail, head, or AUTO position, the ECU sends an auto dimmer signal to the combination meter assembly.

According to this signal, the combination meter assembly dims the meter illumination.

HINT:

When the meter illumination does not dim at night, there may be a malfunction in the automatic light control sensor, main body ECU (multiplex network body ECU), CAN communication system, wire harness, connector, or combination meter assembly.


WIRING DIAGRAM

E230682E33
1.115,1.646 2.76,2.021 1.646,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 4.313,1.708 6.177,1.938 1.865,0.229 10 false Combination Meter Assembly 1.208,2.365 2.979,2.542 1.771,0.177 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



HINT:
·

The automatic light control sensor sensitivity can be customized.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS

·

Setting the meter illumination level to maximum brightness prevents the meter illumination from dimming when the headlight dimmer switch assembly is changed to the tail, head, or AUTO position at night. Therefore, check the meter illumination setting before proceeding to the following steps.



PROCEDURE

1.CHECK FOR DTC
a.

Check if lighting system DTCs are output.

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Result Proceed to
DTC B1244 is not output. A
DTC B1244 is output. B



A

2.CHECK COMBINATION METER ASSEMBLY

B

2.CHECK COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly with a new one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


OK:

The operation of the combination meter assembly returns to normal.


Result:
Proceed to
OK
NG



OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)