| *A | w/ TOYOTA Parking Assist-sensor System | *B | w/ Advanced Park |
| *C | w/ Panoramic View Monitor System | - | - |
| ● | Non-reusable part | - | - |
| *A | w/ TOYOTA Parking Assist-sensor System | *B | w/ Advanced Park |
| *1 | FRONT BUMPER COVER | - | - |
| ● | Non-reusable part | - | - |
89341L
1.REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341K
2.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341M
3.REMOVE FRONT SIDE ULTRASONIC SENSOR (w/ Advanced Park)
89C48D
4.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
88211B
6.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
86790B
7.REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
81520
8.REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY LH
81510
9.REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52114B
10.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET
52113D
11.REMOVE FRONT BUMPER EXTENSION LH
52112D
12.REMOVE FRONT BUMPER EXTENSION RH
Use the same procedure described for the LH side.
82114C
13.REMOVE FRONT NO. 4 COMPARTMENT WIRE
| *A | w/ TOYOTA Parking Assist-sensor System | *B | w/ Advanced Park |
| *C | w/ Panoramic View Monitor System | - | - |
89348X
14.REMOVE FRONT ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)
| *A | w/ Advanced Park | - | - |
Heat the adhesive of the front ultrasonic sensor clip using a heat light.
| Part | Temperature |
|---|---|
| Front Ultrasonic Sensor Clip | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front ultrasonic sensor clip excessively.
Remove each front ultrasonic sensor clip.
53395E
15.REMOVE HOOD TO FRONT END PANEL SEAL
53115H
16.REMOVE RADIATOR GRILLE BRACKET
|
Screw |
|
Clip |
52127C
17.REMOVE FRONT BUMPER HOLE COVER
|
Anti-drop hook | - | - |
53127A
18.REMOVE LOWER RADIATOR GRILLE RH
75311
19.REMOVE RADIATOR GRILLE EMBLEM
53101
20.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
53102A
21.REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY
53123D
22.REMOVE LOWER RADIATOR GRILLE MOULDING
23.REMOVE FRONT BUMPER ENERGY ABSORBER SUB-ASSEMBLY
| *a | Goes off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
|
Bolt |
|
Airbag Connector |
Disconnect the 2 airbag connectors.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Remove the 3 bolts.
Detach the claw and guide and remove the front bumper energy absorber sub-assembly.
51466
24.REMOVE UPPER RADIATOR SUPPORT BRACE LH
|
Bolt |
|
Nut |
51465
25.REMOVE UPPER RADIATOR SUPPORT BRACE RH
|
Bolt |
|
Nut |
|
Connector | - | - |
52021
26.REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
16683A
27.REMOVE LOWER RADIATOR AIR GUIDE PLATE
|
Remove in this Direction | - | - |
52029B
28.REMOVE FRONT BUMPER NO. 2 REINFORCEMENT SUB-ASSEMBLY
52116A
29.REMOVE FRONT BUMPER SIDE SUPPORT LH
| *a | 90° | - | - |
|
Clip |
|
Rotation Direction |
52115A
30.REMOVE FRONT BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.