Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM37H0E _54 Brake _097302 BRAKE (FRONT) _0455487 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C451724N06
4.417,6.833 6.167,8.333 1.75,1.5 0.917,5.667 2.5,7.25 1.583,1.583 2.656,6.26 4.26,7.615 1.604,1.354 2.656,4.573 4.948,6.188 2.292,1.615 3.708,6.958 3.708,6.417 true 2.917,8.5 3.917,8.5 3.917,8.5 3.917,8.156 true 3.083,8.5 3.083,7.948 true 3.917,5.99 3.917,5.073 3.917,5.073 3.667,5.073 true 6.167,7.625 6.313,7.625 true 0.417,6.417 0.917,6.417 true 3.854,6.417 3.083,6.417 3.083,6.417 3.083,6.646 true 3.667,5.625 3.917,5.625 true 4.188,5.083 4.438,5.083 true 2.917,5.188 2.917,5.688 true 4.313,5.896 4.417,5.667 4.417,5.667 4.583,5.667 true 6.563,0.583 6.813,0.583 true 6.594,0.167 6.844,0.167 true 6.615,0.969 6.865,0.969 true 5.823,3.917 6,4.25 6,4.25 6.167,4.25 true 1.438,6.125 1.5,5.917 1.5,5.917 1.667,5.917 true 1.604,6.833 1.75,6.833 1.75,6.833 1.833,6.708 true 5.167,8 5.333,8 5.333,8 5.458,7.865 true 5.021,7.271 5.083,7.083 5.083,7.083 5.25,7.083 true 4.26,6.542 4.677,6.542 false 4.948,5.25 5.198,5.25 false 6.375,0.031 6.625,0.354 0.25,0.323 18 false 1 6.365,0.438 6.615,0.76 0.25,0.323 18 false 2 6.396,0.833 6.646,1.156 0.25,0.323 18 false 4 5.094,6.406 5.396,6.729 0.302,0.323 18 false 6 6.271,4.083 6.521,4.406 0.25,0.323 18 false 3 6.417,7.49 6.719,7.813 0.302,0.323 18 true 7 0.104,6.25 0.406,6.573 0.302,0.323 18 true 7 4.521,5 4.833,5.198 0.313,0.198 10 false *1 1.396,6.76 1.667,7 0.271,0.24 10 false *2 5.313,6.99 5.583,7.229 0.271,0.24 10 false *2 1.74,5.844 2.01,6.083 0.271,0.24 10 false *3 4.979,7.938 5.25,8.177 0.271,0.24 10 false *3 3.844,6.021 4.156,6.219 0.313,0.198 10 false *5 2.844,5.719 3.104,5.958 0.26,0.24 10 false *4 2.708,8.427 3.021,8.625 0.313,0.198 10 false *6 4.667,5.563 4.938,5.802 0.271,0.24 10 false *7 3.906,6.354 4.177,6.594 0.271,0.24 10 false *8 5.281,5.115 5.583,5.438 0.302,0.323 18 false 5

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISABLE BRAKE CONTROL - - - (Click here)
3 FRONT WHEEL - - - -
4 DRAIN BRAKE FLUID - - (Click here) -
5 FRONT DISC BRAKE FITTING KIT 04947 - - -
6 FRONT DISC BRAKE PAD KIT 04465 (Click here) - -
7 FRONT ANTI SQUEAL SHIM KIT 04945 - - -

*1 NO. 1 ANTI-RATTLE SPRING *2 NO. 1 ANTI-SQUEAL SHIM
*3 NO. 2 ANTI-SQUEAL SHIM *4 PIN HOLD CLIP
*5 HOLE PIN *6 INNER ANTI-RATTLE SPRING
*7 ANTI-SQUEAL SPRING *8 FRONT DISC BRAKE PAD

C437777N05
4.281,4.531 4.948,4.531 true 6.177,3.229 6.333,3.5 6.333,3.5 6.5,3.5 true 4.667,0.563 4.833,0.333 4.833,0.333 5,0.333 true 3.75,0.792 4.063,0.792 true 4.24,1.271 3.906,2.104 3.906,2.104 3.656,2.104 true 6.594,3.354 6.896,3.625 0.302,0.271 18 false 9 5.219,4.396 5.625,4.76 0.406,0.365 18 false 10 3.406,1.948 3.823,2.375 0.417,0.427 18 false 8 5.094,0.24 5.76,0.573 0.667,0.333 10 false ● *1 3.385,0.677 3.875,1.031 0.49,0.354 10 false ● *2 5.031,2.302 5.344,2.5 0.313,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

8 FRONT FLEXIBLE HOSE 47313J - - -
9 DISC BRAKE CYLINDER ASSEMBLY LH - - - -
10 FRONT DISC 43512 (Click here) - -

*1 GASKET *2 UNION BOLT
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front disc brake removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

NOTICE:
·

Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.

·

After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.

·

After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.

·

When removing or installing the front disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.

·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the RH and LH sides, except where indicated.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISABLE BRAKE CONTROL

Z101186

Click here(Click here)

Hide 3.REMOVE FRONT WHEEL

Hide 4.DRAIN BRAKE FLUID

Z101186

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.



Hide 04947 5.REMOVE FRONT DISC BRAKE FITTING KIT

Hide 04465 6.REMOVE FRONT DISC BRAKE PAD KIT

Z101186

Click here(Click here)

Hide 04945 7.REMOVE FRONT ANTI SQUEAL SHIM KIT

Hide 47313J 8.REMOVE FRONT FLEXIBLE HOSE

a.
C437779


Hide 47750 9.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

a.
C437780


Hide 43512 10.REMOVE FRONT DISC

a.
C437781C01
3.281,0.875 2.521,0.698 2.521,0.698 3.302,0.813 true 0.427,0.031 1.198,0.354 0.771,0.323 18 false i, ii 2.26,0.615 2.469,0.802 0.208,0.188 10 true *a
*a Matchmark - -


i.

Put matchmarks on the front disc LH and the front axle hub sub-assembly LH.

HINT:

Not required when replacing the front disc LH.



ii.

Remove the front disc LH.