| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | DRAIN WINDSHIELD WASHER FLUID | - | ( )
|
- | - |
| 7 | WASHER MOTOR & PUMP ASSEMBLY | 85310C | - | - | - |
| 8 | WINDSHIELD WASHER JAR BUSH | 85330A | - | - | - |
1.REMOVE FRONT WHEEL LH
53852B
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
53806C
3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
| *a | Protective Tape | - | - |
|
Screw |
|
Clip |
Remove the 6 screws and 3 clips.
Using a screwdriver, detach the claw and remove some of the front fender splash shield shb-assembly LH as shown in the illustration.
Tape the screwdriver tip before use.
47749F
4.REMOVE PIN HOLD CLIP
53879H
5.REMOVE FRONT FENDER LINER RETAINER
6.DRAIN WINDSHIELD WASHER FLUID
Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
Use a container to collect the washer fluid.
85310C
7.REMOVE WASHER MOTOR & PUMP ASSEMBLY
|
Remove in this Direction | - | - |
85330A
8.REMOVE WINDSHIELD WASHER JAR BUSH