0,0 0,0
false
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
48818
1.INSTALL REAR STABILIZER BUSHING
| *a | Cutout | *b | Stopper |
|
Front of the Vehicle | - | - |
Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.
Be sure to install the stoppers so that each cutout faces the inside of the vehicle.
Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.
48833R
2.INSTALL REAR NO.1 STABILIZER BAR BRACKET LH
| *a | Arrow Mark | - | - |
|
Front of the Vehicle | - | - |
Install the rear No. 1 stabilizer bar bracket LH to the rear stabilizer bushing.
Be sure to install the rear No. 1 stabilizer bar bracket LH so that each arrow mark faces the front of the vehicle.
48832R
3.INSTALL REAR NO.1 STABILIZER BAR BRACKET RH
Perform the same procedure as for the LH side.
48812
4.INSTALL REAR STABILIZER BAR
Install the rear stabilizer bar with the 4 bolts.
Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).
48830D
6.TEMPORARILY TIGHTEN REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
51206A
7.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY