Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C124000  Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A"  


DESCRIPTION

The airbag ECU assembly has a built-in yaw rate and acceleration sensor.

If the identification ID of the yaw rate and acceleration sensor (airbag ECU assembly) is different to that stored in the No. 2 skid control ECU (brake actuator assembly), this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C124000 Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A" The yaw rate and acceleration sensor (airbag ECU assembly) identification information stored in the No. 2 skid control ECU (brake actuator assembly) is not consistent with the yaw rate and acceleration sensor (airbag ECU assembly) identification information sent via CAN communication continuously for 1 second or more.
·

Incorrect yaw rate and acceleration sensor (airbag ECU assembly) installed

·

No. 2 skid control ECU (brake actuator assembly)


Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY



PROCEDURE

1.CHECK PART NUMBER (AIRBAG ECU ASSEMBLY)
a.

Check that the part number of the installed yaw rate and acceleration sensor (airbag ECU assembly) is correct.

OK:

Yaw rate and acceleration sensor (airbag ECU assembly) installed in the vehicle has the correct part number.



Result:
Proceed to
OK
NG



OK

2.CLEAR DTC

NG

2.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435
Result:
Proceed to
NEXT



Post-procedure1

a.

Turn the ignition switch off.



NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC

Pre-procedure1

a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


Procedure1

a.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435
Result:
Result Proceed to
C124000 is not output A
C124000 is output B



Post-procedure1

a.

None



A

B