Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C05121F  Right Rear Wheel Speed Sensor Circuit Intermittent  


DESCRIPTION

Refer to DTC C051212.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C051212

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C05121F Right Rear Wheel Speed Sensor Circuit Intermittent Any of the following is detected:
·

When the +BS terminal voltage is 17.4 V or less, an open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.


·

Rear speed sensor RH

·

Rear speed sensor installation

·

Rear speed sensor rotor RH (rear axle hub and bearing assembly RH)


Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

C05121F DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnosis Condition When the +BS terminal voltage is 17.4 V or less ○ ○ ○
Malfunction Status An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more ○ - -
At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds - ○ -
At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation - - ○
Detection Time - - 15 seconds or more.
Number of Trips 1 trip 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>TEST MODE PROCEDURE

·

After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>TEST MODE PROCEDURE



PROCEDURE

1.READ VALUE USING GTS (RR WHEEL SPEED AND MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear speed sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Momentary interruption of rear speed sensor RH pulse input to ECU Normal / Under intermittent Normal: Normal
Under intermittent: Momentary interruption
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK REAR SPEED SENSOR RH INSTALLATION
2.CHECK REAR SPEED SENSOR RH INSTALLATION
a.
C168336C07
0.76,1.917 1.083,2.083 0.323,0.167 10 *a 2.417,1.917 2.74,2.083 0.323,0.167 10 *b
*a Correct
*b Incorrect


Check the rear speed sensor RH installation.

OK:

There is no clearance between the rear speed sensor RH and the rear axle carrier RH.



Result:
Proceed to
OK
NG



OK

3.CHECK REAR SPEED SENSOR RH (CHECK FOR FOREIGN MATTER)

NG

INSTALL REAR SPEED SENSOR RH CORRECTLY

3.CHECK REAR SPEED SENSOR RH (CHECK FOR FOREIGN MATTER)
a.

Remove the rear speed sensor RH, and confirm that there is no foreign matter, oil or grease on the rear speed sensor tip RH.

OK:

The rear speed sensor tip RH is free of oil and foreign matter.


HINT:

If foreign matter of 1 mm (0.03937 in.) x 1 mm (0.03937 in.) or more is adhered to the rear speed sensor RH, this DTC may be stored.



Result:
Proceed to
OK
NG



OK

4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)

NG

7.CLEAN REAR SPEED SENSOR RH
4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)
a.

Confirm that there is no foreign matter, oil or grease on the rear speed sensor rotor RH.

OK:

The rear speed sensor rotor RH is free of oil and foreign matter.


HINT:
·

If foreign matter of 1 mm (0.03937 in.) x 1 mm (0.03937 in.) or more is adhered to the rear speed sensor rotor RH, this DTC may be stored.

·

The rear speed sensor rotor RH is incorporated into the rear axle hub and bearing assembly RH.

If the rear speed sensor rotor RH needs to be replaced, replace it together with the rear axle hub and bearing assembly RH.




Result:
Proceed to
OK
NG



OK

REPLACE REAR SPEED SENSOR RH AND COMPONENT WITH REAR SPEED SENSOR ROTOR RH

NG

5.CLEAN REAR SPEED SENSOR ROTOR RH
5.CLEAN REAR SPEED SENSOR ROTOR RH
a.

Clean the rear speed sensor rotor RH.

NOTICE:

Do not use parts cleaner when cleaning the rear speed sensor rotor RH.



Result:
Proceed to
NEXT



NEXT

6.READ VALUE USING GTS (RR WHEEL SPEED AND MOMENTARY INTERRUPTION)
6.READ VALUE USING GTS (RR WHEEL SPEED AND MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear speed sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Momentary interruption of rear speed sensor RH pulse input to ECU Normal / Under intermittent Normal: Normal
Under intermittent: Momentary interruption
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.


HINT:

The rear speed sensor rotor RH is incorporated into the rear axle hub and bearing assembly RH.

If the rear speed sensor rotor RH needs to be replaced, replace it together with the rear axle hub and bearing assembly RH.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE REAR SPEED SENSOR RH AND COMPONENT WITH REAR SPEED SENSOR ROTOR RH

7.CLEAN REAR SPEED SENSOR RH
a.

Clean the rear speed sensor RH.

NOTICE:

When cleaning the rear speed sensor RH, make sure to clean the installation hole before installation.



Result:
Proceed to
NEXT



NEXT

8.READ VALUE USING GTS (RR WHEEL SPEED AND MOMENTARY INTERRUPTION)
8.READ VALUE USING GTS (RR WHEEL SPEED AND MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear speed sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Momentary interruption of rear speed sensor RH pulse input to ECU Normal / Under intermittent Normal: Normal
Under intermittent: Momentary interruption
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

END

NG

4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)