Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0453477 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P1C9F11  Hybrid/EV Battery Current Sensor for Driving Control Circuit Short to Ground  P1C9F15  Hybrid/EV Battery Current Sensor for Driving Control Circuit Short to Auxiliary Battery or Open  


DESCRIPTION

Refer to the description for DTC P0ABF11.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0ABF11

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P1C9F11 Hybrid/EV Battery Current Sensor for Driving Control Circuit Short to Ground "EV Battery Current for Driving Control" (terminal IBA voltage) is excessively low (stuck at 5 V).
(1 trip detection logic)
Battery ECU assembly Master Warning:
Comes on
EV Battery A
P1C9F15 Hybrid/EV Battery Current Sensor for Driving Control Circuit Short to Auxiliary Battery or Open "EV Battery Current for Driving Control" (terminal IBA voltage) is excessively low (stuck at 0 V).
(1 trip detection logic)
Battery ECU assembly Master Warning:
Comes on
EV Battery A

A380484E02
0.896,2.979 2.583,3.177 1.688,0.198 10 false Battery Current Sensor 4.906,2.854 6.156,3.094 1.25,0.24 10 false Analogue / Digital 4.906,3.042 6.083,3.354 1.177,0.313 10 false Converter Circuit 3.823,3.427 5.688,3.625 1.865,0.198 10 false Battery ECU Assembly 5.49,3.427 6.156,3.656 0.667,0.229 10 false C1 < C2 4.5,2.448 4.917,2.688 0.417,0.24 10 false C2 4.51,1.646 4.927,1.885 0.417,0.24 10 false C1 5.219,2.292 5.635,2.531 0.417,0.24 10 false IBA 5.219,1.49 5.635,1.729 0.417,0.24 10 false IB0 3.573,1.354 3.99,1.594 0.417,0.24 10 false IB 4.396,1.167 4.813,1.406 0.417,0.24 10 false VIB

Related Data List
DTC No. Data List
P1C9F11
·

Hybrid/EV Battery Current for Hybrid/EV Battery Control

·

Hybrid/EV Battery Current for Driving Control


P1C9F15

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 10 minutes or more.

3.

Turn the ignition switch to ON and wait for 10 seconds or more.

4.

Enter the following menus: Powertrain / EV Battery / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




PROCEDURE

1.CHECK DTC OUTPUT (EV BATTERY, EV)

Pre-procedure1

a.

None.


Procedure1

a.

Check for DTCs.

Powertrain > EV Battery > Trouble Codes
50001 398
Powertrain > EV > Trouble Codes
50001 397
Result:
Result Proceed to
Only P1C9F11 or P1C9F15 for Hybrid battery system is output A
P1C9F11 or P1C9F15 is output and DTCs other than the DTCs in the table below are output B
P1C9F11 or P1C9F15 is output and Hybrid battery system DTCs in the table below are output C
P1C9F11 or P1C9F15 is output and Hybrid control system DTCs in the table below are output D


System Relevant DTC
Hybrid battery system P060A47 Hybrid/EV Battery Energy Control Module Monitoring Processor Watchdog / Safety MCU Failure
P060B49 Hybrid/EV Battery Energy Control Module A/D Processing Internal Electronic Failure
P060687 Hybrid/EV Battery Energy Control Module Processor to Monitoring Processor Missing Message
P0ABF11 Hybrid/EV Battery Current Sensor "A" Circuit Short to Ground
P0ABF15 Hybrid/EV Battery Current Sensor "A" Circuit Short to Auxiliary Battery or Open
P0ABF28 Hybrid/EV Battery Current Sensor "A" Signal Bias Level Out of Range / Zero Adjustment Failure
P0ABF2A Hybrid/EV Battery Current Sensor "A" Signal Stuck In Range
Hybrid control system P0A1F94 Hybrid/EV Battery Energy Control Module Unexpected Operation


Post-procedure1

a.

Turn the ignition switch off.



A

B

C

GO TO DTC CHART (HYBRID BATTERY SYSTEM)

D