The battery ECU assembly alerts the driver and performs fail-safe control based on malfunction signals.
If the EV supply battery assembly is discharged excessively or the hybrid battery system is malfunctioning, this DTC will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| P300016 | Hybrid/EV Battery Control System Circuit Voltage Below Threshold | A malfunction signal is received from the battery ECU assembly.
The voltage of any EV battery cell has decreased excessively. (1 trip detection logic) |
·
FC system ·
EV supply battery assembly |
Master Warning:
Comes on |
EV Battery | A |
If the EV battery voltage has dropped due to a malfunction in other components, such as the inverter with converter assembly, recharging the EV supply battery assembly will be able to restore the voltage. If the EV battery voltage has dropped excessively after the vehicle was left for a long time, the EV supply battery assembly will need to be replaced.
| DTC No. | Data List |
|---|---|
| P300016 | ·
Hybrid/EV Battery SOC ·
Hybrid/EV Battery Voltage ·
Hybrid/EV Battery Current |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 10 minutes or more.
Enter the following menus: Powertrain / EV / Data List / FC Work Mode, FC Intermittent Operation.
Turn the ignition switch to ON (READY) with park (P) selected and wait until the FC system is activated.
FC system is activated: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.
Wait until the Data List (EV) item "FC Intermittent Operation" turns ON.
Enter the following menus: Powertrain / EV Battery / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Thoroughly interview the customer as DTC P300016 may be stored if the SOC drops due to running out of fuel.
When the FC system cannot be started, DTC P300016 may be stored because the EV supply battery assembly cannot be charged.
If differences among SOCs of EV supply battery assembly exceed the specifications, the hybrid system warning may illuminate when "Battery Diagnosis" is complete. In this case, check for hybrid system related DTCs. If DTC P300016 is output, leave the vehicle with the ignition switch ON (READY) for 10 minutes or more allowing the vehicle to charge the EV supply battery assembly. Then clear the DTCs.
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only P300000 or P300016 is output | A |
| P300000 or P300016 and other DTCs are output | B |
If the EV battery voltage has dropped due to a malfunction in other components such as the inverter with converter assembly, recharge the EV supply battery assembly and then repair the malfunctioning part.
Post-procedure1
Turn the ignition switch off.
A
B
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
If the EV battery voltage has dropped due to a malfunction in other components such as the inverter with converter assembly, recharge the EV supply battery assembly and then repair the malfunctioning part.
Post-procedure1
Turn the ignition switch off.
A
B
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
Turn the ignition switch off.
A
B
Pre-procedure1
Turn the ignition switch to ON (READY).
Procedure1
Check if the FC system starts.
| Tester Display |
|---|
| FC Work Mode |
| FC Intermittent Operation |
Do not turn the ignition switch to ON (READY) repeatedly after duplicating the problem symptom indicated by DTC P300016 and clearing the DTCs. This may cause another problem to occur.
FC system is started: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.
Depressing the accelerator pedal with park (P) selected will cause the FC system to start.
| Result | Proceed to |
|---|---|
| The FC system does not start. | A |
| The FC system starts. | B |
Post-procedure1
Turn the ignition switch off.
A
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>CHARGING
Charge the EV supply battery assembly using the THS charger, then check that FC system starts.
FC system is started: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.
As the EV supply battery assembly is not malfunctioning, it is necessary to charge the EV supply battery assembly with the THS charger.
B