Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455727 ELECTRIC PARKING BRAKE SYSTEM J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  Electric Parking Brake System AUTO Function Circuit  


DESCRIPTION

The No. 2 skid control ECU (brake actuator assembly) receives shift position signals from the EV control ECU via CAN communication to control the electric parking brake system AUTO function (shift-linked).

The electric parking brake system AUTO function (shift-linked) is automatically disabled when the ignition switch is ON, the brake pedal is depressed and the shift state changed from P. Then, if the shift state changed from P, the AUTO function (shift-linked) automatically operates to apply the electric parking brake.

WIRING DIAGRAM

C396297E11
0.958,0.656 3.302,0.958 2.344,0.302 10 false EV Control ECU 0.938,1.063 3.073,1.448 2.135,0.385 10 false - Shift Position Signal 5.604,1.49 6.979,2.094 1.375,0.604 10 false No. 2 Skid Control ECU (Brake Actuator Assembly) 1.25,2.281 3.385,2.667 2.135,0.385 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

The AUTO function (shift-linked) will not be automatically disabled when the ignition switch is ON, the brake pedal is depressed and the shift state changed from P if the electric parking brake switch assembly is moved to the engage side. The AUTO function (shift-linked) will not automatically operate to apply the electric parking brake when the shift state changed from P if the electric parking brake switch assembly is moved to the release side.

·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>UTILITY



PROCEDURE

1.CHECK DTC (HYBRID CONTROL SYSTEM)
a.

Check for DTCs.

Powertrain > Hybrid Control > Trouble Codes
50001 397
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

B