Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455727 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  C059704  Brake System Control Module "A" System Internal Failure  C059746  Brake System Control Module "A" Calibration / Parameter Memory Failure  C11351C  Unified Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range  


DESCRIPTION

The following DTCs are stored when a malfunction occurs in the No. 2 skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from Priority Note
C059704 Brake System Control Module "A" System Internal Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored Brake/EPB A An electric parking brake system malfunction is displayed on the multi-information display.
C059746 Brake System Control Module "A" Calibration / Parameter Memory Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored Brake/EPB A An electric parking brake system malfunction is displayed on the multi-information display.
C11351C Unified Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored Brake/EPB A An electric parking brake system malfunction is displayed on the multi-information display.

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>UTILITY



PROCEDURE

1.REPLACE NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

NEXT

END