Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455115 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C2A5D  BSM Buzzer Malfunction  


DESCRIPTION

This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C2A5D BSM Buzzer Malfunction The RCTA buzzer circuit is abnormal. Blind spot monitor system Rear Camera A

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.READ VALUE USING GTS (BLIND SPOT MONITOR SENSOR LH STATUS)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Blind Spot Monitor Slave > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Buzzer Connection Status of the buzzer connection Valid or Invalid Valid: Buzzer connection is valid
Invalid: Buzzer connection is invalid
-
Slave Side RCTA Function Switches the RCTA function on and off OFF or ON OFF: RCTA function off
ON: RCTA function on
-
Body Electrical > Blind Spot Monitor Slave > Data List
Tester Display
Buzzer Connection
Slave Side RCTA Function
50003 314 72,65
Result:
Result Proceed to
"Valid" and "ON" is displayed for all items. A
"Invalid" or "OFF" is displayed. B




A

2.CLEAR DTC

B

2.CLEAR DTC
a.

Clear the DTCs.

Chassis > Rear Camera > Clear DTCs
50002 85

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85

Result:
Result Proceed to
C2A5D is output A
C2A5D is not output B



A

4.CHECK FOR DTC (BLIND SPOT MONITOR SYSTEM [C1ABE])

B

4.CHECK FOR DTC (BLIND SPOT MONITOR SYSTEM [C1ABE])
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
C1ABE is output A
C1ABE is not output B



A

GO TO DIAGNOSTIC TROUBLE CODE CHART (C1ABE)

B

GO TO BLIND SPOT MONITOR SYSTEM (PROBLEM SYMPTOMS TABLE)