Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455114 BLIND SPOT MONITOR SYSTEM T

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the auxiliary battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART




HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Entire System
Symptom Suspected Area Link
System does not operate at all CAN communication system Click here
Meter / gauge system Click here
Proceed to "Power Source Circuit" Click here
Steering pad switch assembly Click here
Spiral cable sub-assembly Click here
Blind spot monitor sensor RH Click here
System cannot be turned off CAN communication system Click here
Meter / gauge system Click here
Steering pad switch assembly Click here
Spiral cable sub-assembly Click here
Blind spot monitor sensor RH Click here
"BSM Not Available" or "BSM Malfunction Visit Your Dealer" is displayed on the multi-information display Check abnormality history Click here
Blind spot monitor sensor LH Click here
Blind spot monitor sensor RH Click here
Combination meter assembly Click here

Blind Spot Monitor Function
Symptom Suspected Area Link
Outer rear view mirror indicator RH does not illuminate Proceed to "Blind Spot Monitor Beam Axis Confirmation" Click here
Outer mirror RH (outer rear view mirror indicator RH) Click here
Front multiplex network door ECU RH Click here
Outer mirror retractor assembly RH Click here
Blind spot monitor sensor RH Click here
Outer rear view mirror indicator LH does not illuminate Proceed to "Blind Spot Monitor Beam Axis Confirmation" Click here
Outer mirror LH (outer rear view mirror indicator LH) Click here
Front multiplex network door ECU LH Click here
Outer mirror retractor assembly LH Click here
Blind spot monitor sensor LH Click here
Outer rear view mirror indicator RH remains illuminated Proceed to "Blind Spot Monitor Beam Axis Confirmation" Click here
Blind spot monitor sensor RH Click here
Outer rear view mirror indicator LH remains illuminated Proceed to "Blind Spot Monitor Beam Axis Confirmation" Click here
Blind spot monitor sensor LH Click here
Outer rear view mirror indicator RH does not flash Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section Click here
Blind spot monitor sensor RH Click here
Outer rear view mirror indicator LH does not flash Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section Click here
Blind spot monitor sensor LH Click here
Outer rear view mirror indicator RH continues to flash Blind spot monitor sensor RH Click here
Outer rear view mirror indicator LH continues to flash Blind spot monitor sensor LH Click here

RCTA Function
Symptom Suspected Area Link
Function does not operate at all
(Blind spot monitor function operates normally)
Data List / Active Test Click here
Hybrid control system -
Blind spot monitor sensor RH Click here
"Rear Cross Traffic Alert Unavailable See Owner's Manual" or "Rear Cross Traffic Alert Malfunction Visit Your Dealer" is displayed on multi-information display Check abnormality history Click here
Blind spot monitor sensor RH Click here
Blind spot monitor sensor LH Click here
Combination meter assembly Click here
While RCTA function is active, outer rear view mirror indicator flashes but RCTA buzzer does not sound Proceed to "Buzzer does not Sound" Click here
Blind spot monitor sensor RH Click here
When shift position is in R, detection operation is normal but RCTA indicator does not appear on display CAN communication system Click here
Rear television camera assembly*1 Click here
Parking assist ECU*2 Click here
Blind spot monitor sensor LH Click here
Blind spot monitor sensor RH Click here
Multi-display assembly*3 Click here
Radio and display receiver assembly*4 Click here

*1: w/ Parking Assist Monitor System

*2: w/ Panoramic View Monitor System

*3: w/ Navigation System

*4: w/ Audio and Visual System

Automatic Rear Flashing Hazard Lights function (w/ Automatic Rear Flashing Hazard Lights Function)
Symptom Suspected Area Link
The automatic rear flashing hazard lights function does not operate CAN communication system Click here
Meter / gauge system Click here
Perform Active Test (Activate the FHL) Click here
Harness or connector -
Combination meter assembly Click here
Blind spot monitor sensor LH Click here
Blind spot monitor sensor RH Click here
"FHL Not Available" or "FHL Malfunction Visit Your Dealer" is displayed on the multi-information display in the combination meter assembly Check abnormality history Click here
Blind spot monitor sensor LH Click here
Blind spot monitor sensor RH Click here
Combination meter assembly Click here