Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM37H0E _58 Vehicle Interior _095297 SEAT BELT _0448140 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B607678N03
3.896,2.719 4.354,2.719 false 4.656,3.521 5.135,3.521 false 6.354,0.188 6.885,0.188 false 6.313,0.594 6.844,0.594 false 6.146,0.031 6.333,0.344 0.188,0.313 18 false 1 5.406,3.396 5.677,3.719 0.271,0.323 18 false 2 4.625,2.583 4.896,2.906 0.271,0.323 18 false 3 6.104,0.438 6.292,0.75 0.188,0.313 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 SEAT BELT ANCHOR COVER CAP LH 73179A (Click here) - -
3 FRONT SEAT OUTER BELT ASSEMBLY LH (ANCHOR) 73220 (Click here) - -
4 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -

B607773N01
0.875,4.302 0.875,4.844 false 5.99,2.729 5.573,2.729 false 3.292,2.896 2.729,2.896 false 5.333,0.802 5.76,0.802 false 1.427,1.656 1.948,1.656 false 3.813,0.719 4.219,0.719 false 4.542,1.906 4.927,1.906 false 2.469,0.74 2.469,0.542 2.469,0.542 2.76,0.542 false 6.219,3.76 6.625,3.76 false 5.615,4.823 5.948,4.823 false 0.813,4.865 1.021,5.188 0.208,0.323 18 false 5 6.042,2.573 6.25,2.896 0.208,0.323 18 false 6 2.5,2.74 2.708,3.063 0.208,0.323 18 false 9 6.042,0.667 6.25,0.99 0.208,0.323 18 false 8 1.208,1.521 1.417,1.844 0.208,0.323 18 false 7 4.26,0.563 4.625,0.885 0.365,0.323 18 false 10 5.167,1.771 5.49,2.094 0.323,0.323 18 false 11 2.427,0.76 2.583,0.958 0.156,0.198 10 false ● 5.656,3.344 5.969,3.542 0.313,0.198 10 false x 2 2.979,1.375 3.292,1.573 0.313,0.198 10 false x 2 6.823,3.625 7.156,3.938 0.333,0.313 18 false 13 6.167,4.688 6.49,5.01 0.323,0.323 18 false 12

Procedure Part Name Code
Z101186

Z101188

Z101187

5 FRONT DOOR SCUFF PLATE LH 67914B - - -
6 REAR DOOR SCUFF PLATE INSIDE LH 67918F - - -
7 FRONT DOOR OPENING TRIM WEATHERSTRIP LH 62312B (Click here) - -
8 REAR DOOR OPENING TRIM WEATHERSTRIP LH 62332A (Click here) - -
9 LOWER CENTER PILLAR GARNISH LH 62414A - - -
10 CENTER PILLAR GARNISH ASSEMBLY LH 62420A - - -
11 FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH 73024 (Click here) - -
12 FRONT SEAT OUTER BELT ASSEMBLY LH 73220 (Click here) - -
13 FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 73200A (Click here) - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat outer belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.

·

Move both front seats to the frontmost position and fold them forward.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B401522

Be sure to read precaution thoroughly before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 73179A 2.REMOVE SEAT BELT ANCHOR COVER CAP LH

Hide 73220 3.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (ANCHOR)

a.
B603148C03
0.771,0.115 1.052,0.469 0.281,0.354 18 true i 5.76,0.635 5.948,0.906 0.188,0.271 18 true ii 5.51,1.313 5.729,1.594 0.219,0.281 18 true iii 0.25,0.156 0.625,0.396 0.375,0.24 12 false *A
*A for Driver Seat - -


i.

for Driver Seat:

1. Move the front seat assembly LH to the lowermost position.


ii.

Remove the bolt.


iii.

Detach the guide and disconnect the anchor of the front outer belt assembly LH.



Hide 4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 67914B 5.REMOVE FRONT DOOR SCUFF PLATE LH

Z101186

·

Use the same procedure described for the RH side.

Click here(Click here)



Hide 67918F 6.REMOVE REAR DOOR SCUFF PLATE INSIDE LH

Hide 62312B 7.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Z101186

HINT:

Remove a part of the front door opening trim weatherstrip LH so that the lower center pillar garnish LH and center pillar garnish assembly LH can be removed.



Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR OPENING TRIM WEATHERSTRIP>REMOVAL

Hide 62332A 8.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Z101186

HINT:

Remove a part of the rear door opening trim weatherstrip LH so that the lower center pillar garnish LH and center pillar garnish assembly LH can be removed.



Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP>REMOVAL

Hide 62414A 9.REMOVE LOWER CENTER PILLAR GARNISH LH

Hide 62420A 10.REMOVE CENTER PILLAR GARNISH ASSEMBLY LH

Hide 73024 11.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH

Z101186

HINT:

Perform this procedure when replacing the front shoulder belt anchor plate sub-assembly LH.



a.
B607680


Hide 73220 12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B607681N01
1.385,0.906 1.521,1.208 0.135,0.302 18 true i 0.708,2.375 0.99,2.729 0.281,0.354 18 false ii 2.563,4.729 2.813,5.031 0.25,0.302 18 true iii 5.813,2.094 6.063,2.396 0.25,0.302 18 true iv 6.083,3.365 6.333,3.667 0.25,0.302 18 true iv 5.229,3.208 5.417,3.5 0.188,0.292 18 true v 5.927,3.052 6.115,3.344 0.188,0.292 18 true v

i.

Remove the nut and shoulder anchor of the front seat outer belt assembly LH.


ii.

Using a thin-bladed screwdriver, release the lock as shown in the illustration and disconnect the pretensioner connector.

HINT:

Tape the thin-bladed screwdriver tip before use.



iii.

Disconnect the tension reducer connector.


iv.

Remove the bolt A and bolt B.


v.

Detach the guide and remove the front seat outer belt assembly LH.



Hide 73200A 13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

Z101186

HINT:

Perform this procedure when replacing the front shoulder belt anchor adjuster assembly.



a.
B607683